Road Angel Navigator User Manual - page 47
ROAD ANGEL Navigator loses the satellite signal (the speed display is not
shown)
1. This may happen temporarily owing to tunnels, tall buildings, bridges or
dense foliage. When you are clear of the obstruction, ROAD ANGEL
Navigator should re-acquire satellite signals in a few seconds.
2. Have you moved the unit within the vehicle? Reposition ROAD ANGEL
Navigator to its original position.
3. You may be experiencing poor GPS coverage – very occasionally one or
more satellites are out of sequence and the signal temporarily drops out.
It should be restored within minutes.
No audible signal
On powering the unit, irrespective of the volume level, the unit will
sound. If you can hear this then the volume has been adjusted to
minimum.
a) Press the MENU button on the front of the unit (see page 2).
b) Tap the OPEN button and then NEXT to view the Camera alert
volume setting.
c) Tap the EDIT button to edit the value.
d) Tap ADJUST repeatedly until the display shows the required value.
e) Tap on the STORE button to save the setting. ROAD ANGEL
Navigator confirms that the setting has been stored.
f) Tap on the EXIT button.
I am not getting a warning on all fixed cameras
1. Has the unit been updated recently? Carry out an update to add all the
new locations (see page 40).
2. ROAD ANGEL Navigator has a directional feature that allows it to ignore
cameras that are enforcing the speed limit in the opposite direction.
43