SAB 3606 User Manual - page 22
22
have to key in password, set “No” means
unlock.
3
Channel Lock determining that when user
wish to play the lock channels, whether
have to input the password or not. If the
setting is “Yes”, play the channels with lock
mark will show up a dialogue on the screen
and ask for the password. If the setting of
“Channel Lock ”is “No”, the Lock function
will invalid.
4
New Password is used for revising
password; you can input the new password
in this item by using number keys directly.
After you filled in 4 digital numbers, the
highlight will auto skip to Confirm Password
and ask you to input the new password
again. If the password is correct, the screen
will show up a message of “Saving Data,
Please Wait…”. After finish saving and
draw back to “System Setup” menu, the
revising is complete.
Press [exit] key to draw back from the “Parental
Lock” menu.
11.3 A/V Control
When you enter to “TV System” menu, you will
see the screen like below:
Display Mode is for switching the system
outputting video resolution. Move highlight on it
and press left or right key, it will switch video
resolution circularly by the sequence “by
source<-> by native TV<-> 480i<-> 480P<->
576i<-> 576p<-> 720P<-> 1080i<->1080P”. This
effect is equal to press V.Format Key under Full
Screen and their last setting saving will be efficient
for each others. By Source means system will set
the video output resolution according to the
program it’s playing, different resolution programs
switching perhaps will makes TV screen flickering.
By Native TV means system will be according to
the HDMI TV’s max supported resolution to set its
resolution, if system is not connected to a HMDI
TV, it will set resolution to be default
Aspect Mode is for switching the screen aspect
ratio mode. Now we provide below options: 4:3
PS / 4:3 LB / 16:9/Auto. You can press [Left/Right]
key to select each mode circularly. 16:9 will
provide user pillar box mode it means user use
16:9 TV to display but need to see a 4:3 full display
picture. System will force press wide screen
picture to be narrow and there’re black band on
left and right site. Auto means system won’t do
any aspect ration translation, 16:9 picture source
will be good display on a 16:9 TV but will be too
narrow on a 4:3 TV, and 4:3 picture source will be
too wide
in a 16:9 TV but will be good
display in a 4:3 TV.
Video Output: Press [Left/Right] to select
RGB or YUV.
RF system and RF channel are for user to set the
TV RF modulator output signal VHF/UHF channel
and TV system mode. If your TV is too old to
supports CVBS//HDMI, you can use TV RF cable
to connect STB’s TV RF output port to TV Antenna
input port.
Digital Audio Out is for setting the both SPDIF and
HDMI’s digital audio output mode, it has options
LPCM Out, Auto, You can press [Left/Right] Key to
select each mode circularity. LPCM Out means
system will decode no matter AC3 or PCM audio
track data to be LPCM, digital audio decoder or
HDMI TV will get LPCM digital audio data. Auto
means system will detect which the connected
HDMI TV can decode and then output that data. If
HDMI TV can decode AC3, system just output