Saber Edge LM-21ABS Operator's manual - Installing The Handle
8
• Securely tighten all lower handle bolts
• Install upper handle to lower handle using
5/16th x 2 inch bolts with locking nut. Making
sure cable is on top of the handle
• Install the hanger grass bag support on the
inside left part of the handle using the 5/16 x
2inch bolt.
• Snap on the two cable clamps to the handle
one on the top handle and other on lower han-
dle securing the cable to the handle.
1. Rope Starter
2. Rope Eyelet
Installing the Handle
(continued)
• Installing only the shoulder bolts will create
a floating handle, if operator wants a secured
handle then install the two 1/4inch x 1 bolts in
the corresponding holes above the shoulder
bolts. There are two sets of holes to adjust the
handle height.
Installing the Recoil-starter
Rope in the Rope Eyelet
Important: To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade control bar to the upper handle and pull
the recoil-starter rope and thread it through the rope
eyelet on the handle.
Filling the Engine with Oil
Important: Your machine does not come with
oil in the engine. Before starting the engine,
fill the engine with oil.
1. Move the machine to a level surface.
2. Remove the dipstick.
3. Slowly pour oil into the oil fill tube until the oil
level reaches the Full line on the dipstick.
4. Note: Do not overfill. (type: SAE 30W
detergent oil with an API service classification
of SF, SG, SH, SJ, SL or higher.)
5. Install the dipstick securely.
Warning: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter.
Refer to changing the engine oil.