Saber Edge LM-21ABS Operator's manual - Adjusting The Cutting Height
9
Adjusting the Cutting Height
Warning: Adjusting the cutting height may
bring you into contact with the moving blade,
causing serious injury.
Make sure to stop the engine and wait for all
moving parts to stop.
Never place your fingers under the housing when
adjusting the cutting height.
Caution: If the engine has been running, the
muffler will be hot and can severely burn you.
Keep away from the hot muffler.
This Machine is equipped with 6 different cut
setting ranging from 1 1/8
th
inch to 3- 1/4
th
inch
located on all four wheels.
Unlock the setting by pulling the lever on each
wheel, away from the mower and moving it left or
right, increasing or decreasing the desired cutting
height.
1st:
2nd:
3rd:
4th:
5th:
6th:
1-1/8 inch
1-9/16 inch
2 inch
2-3/8 inch
2-13/16 inch
3-1/4 inch
Starting the Engine
2. Pull the recoil- start handle.
Hold The Blade - Control Bar against the handle.
Important: If the machine does not start after
multiple attempts contact your Authorized Service
Dealer.
Filling the Fuel Tank
Refer to engine manual
Warning/Danger: Gasoline is extremely flammable
and explosive. A fire or explosion from gasoline can
burn you and others.
• To prevent a static charge from igniting the
gasoline, place the container and/or machine
directly on the ground before filling not in a
vehicle or on an object.
• Fill the tank outdoors when the engine is cold.
Wipe up spills.
• Do not handle gasoline when smoking or
around an open flame or sparks.
• Store gasoline in an approved fuel container,
out of the reach of children.
• For best results use clean, fresh, unleaded
gasoline, with a minimum of 87 octane/87 AKI
(91RON).
• Gasoline with up to 10% ethanol (gasohol) is
acceptable.
• For more information refer to engine manual.
Checking the Engine Oil Level
Always check oil level before starting lawn mower.
1. Move the machine to a level surface.
2. Remove the dipstick, wipe it clean, and fully
insert the dipstick.
3. Remove the dipstick and read the oil level. If
the oil level is below the full line , slowly pour
oil into the oil fill tube until the oil level
reaches the Full line on the dipstick.
4. Note: Do not overfill. (type: SAE 30W
detergent oil with an API service classification
of SF, SG, SH, SJ, SL or higher.)
5. Install the dipstick securely.