1. DL manuals
  2. Saber Edge
  3. Lawn Mower
  4. LM-21SBS
  5. Operator's manual

Saber Edge LM-21SBS Operator's manual

Manual is about: 21” Steel Walk Behind Lawn Mower

Summary of LM-21SBS

  • Page 1

    1 warning read and follow all safety rules and instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury operator’s manual 21” steel walk behind lawn mower thank you for purchasing a saber edgelawn mower it was care...

  • Page 2

    2 table of contents slope gauge .................................................................................................................................................. 3 safety ...................................................................................................................

  • Page 3: Slope Gauge

    3 slope gauge use this slope gauge to determine if a slope is too steep for safe operation! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.G. A pole, building, fence, tree, etc.) 3. Align either side o...

  • Page 4: General Operation

    4 general operation note: determine the left and right sides of the machine from the normal operating position • read, understand, and follow all instructions on the machine and in the manual(s) before starting. Keep this manual in a safe place for future and regular reference. • do not operate mach...

  • Page 5: Children and Pets

    5 children and pets tragic accidents can occur if the operator is not alert to the presence of children or pets. Children are often attracted to the machine and the mowing activity. Never assume that children and pets will remain where you last saw them. • be alert and turn mower off if a child or p...

  • Page 6: Safety and

    6 safety and instructional decals important: all damaged or illegible safety and instruction decals should be replaced. They are located near areas of potential danger. Safety warning label danger decal 1. Bladecontrolbar 2. Tractionclutchbar 3. Knob(4) 4. Grasscatcher 5. Cuttingheightlever 6. Handl...

  • Page 7: Rope In The Rope Eyelet

    7 installing the recoil-starter rope in the rope eyelet important: to start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. Hold the blade control bar to the upper handle and pull the recoil-starter rope and thread it through the rope eye...

  • Page 8: To Change Cutting Height:

    8 to change cutting height: first unlock the setting by pulling the leaver away from the mower out towards the right. You can now move the leaver either towards the front wheel (increasing the height) or back towards the rear bag (decreasing the height) . Starting the engine 1. Hold the blade- contr...

  • Page 9: Cutting Grass Tips:

    9 • make sure to clear the area of stones, sticks, branches, wire and other debris that the blade could hit. • never deliberately mow over any object. Avoid striking solid objects with the blade. • if the machine strikes an object or starts to vibrate, immediately stop the engine, disconnect the wir...

  • Page 10: Mulching Tips:

    10 mulching tips: avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the new- ly cut area will not be exposed to direct sunlight. For best results...

  • Page 11: Preparing For Maintenance

    11 preparing for maintenance 1. Stop the engine and wait for all moving parts to stop. 2. Disconnect the spark-plug wire from the spark plug before performing any maintenance proce- dure. 3. After performing the maintenance procedure(s), connect the spark-plug wire to the spark plug. Important: befo...

  • Page 12: Replacing The Blade

    12 replacing the blade service interval: yearly warning: the blade is sharp; contacting the blade can result in serious personal injury. To replace or sharpen the blade it is strongly recommended to have an authorized service dealer perform this task. Examine the blade whenever you run out of gasoli...