SABINE SW75-T BELTPACK TRANSMITTER Quick Setup Manual - Sabine
SIDE
B
© 2007 Sabine, Inc.
SW75-T Beltpack Transmitter Quick Setup Guide
Using your thumb and forefinger, grab both tabs
and simultaneously pull down toward the bottom
of the beltpack. This releases the locks.
2
SABINE
13301 NW US Highway 441 • Alachua, FL 32615-8544 USA • +USA (386) 418-2000 • +USA (386) 418-2001 fax
Sabine@Sabine.com • www.Sabine.com
®
Important Battery Information
Your Sabine 2.4 GHz beltpack transmitter (SW75-T) comes with two size AA rechargeable NiMH batteries.
For best results, charge the battery for at least 8 hours before using it for the first time. Please note that the
full charging potential of the battery will be achieved after the first 5 charging cycles have been completed.
These rechargeable NiMH batteries are highly resistant to the “memory effect,” which affects some recharge-
able batteries. The included batteries will provide more lifetime charges and longer battery life for each charge
than many rechargeable batteries.
Acceptable Batteries for use with SW70-T Beltpack Transmitters
WARNING! DO NOT USE: Alkaline Rechargeable Batteries
DO NOT SHORT CIRCUIT. MUST BE RE-
CYCLED OR DISPOSED OF PROPERLY.
Battery Caution
DO NOT BURN OR PUNCTURE BATTERY.
DOING SO COULD RELEASE TOXIC MA-
TERIALS WHICH COULD CAUSE INJURY.
Alkaline “AA”
Rechargeable
Batteries
Opening Access Compartment
Gently pull the door open.
Closing Access Compartment
1
Swing the door back up and close it by firmly
pushing the top part of the door in until you hear
the locks click.
2 “AA” size (14.5x50.5mm,
• NiMH Rechargeable (Sabine part #: SWBAA2)
• Alkaline: NEDA 14A - ANSI 14A - IEC LR14
• Heavy Duty batteries (NOT recommended)
)
PLEASE
CAREFULLY
READ
THE
OPERATING
GUIDE
FOR
COMPLETE
INSTRUCTIONS
.