Sachtler Reporter 21D MicroSun Instruction Manual - Safety Instructions
- 1 -
Reporter 21D MicroSun
Manual
1
Safety instructions
➪
Do not connect to a power source if you are standing in
water, have wet or damp hands or if connectors or cables
are wet or damp!
➪
Do not place the luminaire in water!
➪
Ensure that sufficient clearance is maintained
to flammable objects whilst operating the
luminaire so that generated heat can easily
dissipate!
➪
Operate luminaire with housing closed and intact protective
glass only!
➪
Handle with care. Do not dispose of!
2
Properties
The Sachtler Reporter 21D MicroSun is designed for use as an
on board camera luminaire. A supply voltage of between 9 to 36
Volts direct voltage suffice to operate the luminaire (at least 11V
must be available when switching on).
The standard 0.75 m power supply lead comes with an
Anton/Bauer Power Tap plug. The luminaire can also be powe-
red from any source with 4 pin XLR sockets, e.g. a Sachtler
Belt-Pack® battery or the Sachtler mains power supply
PowerPack 300 by using the cable XLR-AB (code no. A1204).
Alternately, the luminaire is also available with a 1.5 m cable
with 4 pin XLR connector (code no. R21DX) for direct connec-
tion to such power supplies. To power this version of the
MicroSun from a Power Tap outlet, use Cable AB-XLR (code no.
A1202).
The luminaire can be used in all possible operating positions.
The plastic surface of the luminaire only heats up slightly.
However, in the centre of the safety glass, it develops the maxi-
mum surface temperature of 155°C (311°F), as shown on the
type plate.
0,1m