Sachtler Video 60 Plus EFP User Manual

Other manuals for Video 60 Plus EFP: Manual
Manual is about: Fluid Head

Summary of Video 60 Plus EFP

  • Page 1

    Video 60 plus efp bedienungsanleitung manual hydrokopf fluid head.

  • Page 2

    ? by sachtler. Alle rechte vorbehalten / all rights reserved version: 1.5/03/02 ausgabedatum / issue date: 03/02 bestellnr. / order no.: sko16t050a sachtler gmbh & co. Kg gutenbergstrasse 5 postfach / p.O.Box 1648 d-85716 unterschleissheim d-85706 unterschleissheim germany germany telefon: (+49) 89 ...

  • Page 3

    - i - inhaltsverzeichnis 1 sicherheitshinweise..............................................................1 2 bedienelemente ...................................................................1 3 betrieb ..................................................................................2 3.1 nivell...

  • Page 4

    Table of contents - ii - 1 safety instructions ..............................................................13 2 operating elements ............................................................13 3 operation............................................................................14 3.1 levelling ...

  • Page 5: Sicherheitshinweise

    - 1 - video 60 plus efp bedienungsanleitung 1 sicherheitshinweise ➪ bei aufgesetzter kamera darf die klemmschale des video 60 plus efp nur dann gelöst werden, wenn die kamera mit stativ gegen umkippen gesichert wurde. ➪ beim einsetzen der kameraplatte in den video 60 plus efp die finger nicht in den...

  • Page 6: Betrieb

    Bedienungsanleitung video 60 plus efp - 2 - vertikalbremse aufbau-arretierung steuerring der vertikaldämpfung verriegelungshebel der touch & go klemmung kipphebel für ½ gewichtsausgleichsfeder batteriefach für libellenbeleuchtung einstellknopf für kamera-balanceplatte 3 betrieb 3.1 nivellieren des h...

  • Page 7

    - 3 - video 60 plus efp bedienungsanleitung durch kräftiges antippen der libelle wird die beleuchtung aktiviert. Je nach druckstärke leuchtet die libelle bis zu 45 sekunden. 3.2 entnehmen der kameraplatte der video 60 plus efp ist mit einem touch & go kamera- schnellverschluß ausgestattet. ➪ fassen ...

  • Page 8

    Bedienungsanleitung video 60 plus efp - 4 - ➪ setzen sie die kameraplatte zuerst vorne in die aufnahme ein. ➪ beim einsetzen der kamera mit kameraplatte verriegelt sie sich automatisch und der verriegelungshebel schnellt in die ausgangsposition zurück (hörbares ein- schnappen). 3.4 entnehmen der kam...

  • Page 9

    - 5 - video 60 plus efp bedienungsanleitung ➪ durch vor- und zurückdrehen der spindel verschieben sie die kamera so lange bis sie die position gefunden haben, in der die kamera horizontal ausbalanciert ist. Hecklastige kameras werden durch rechtsdrehen an der spindel nach vorne verschoben, frontlast...

  • Page 10

    Bedienungsanleitung video 60 plus efp - 6 - 3.6.1 ab- bzw. Zuschalten der festeingestellten ausgleichsfedern (sollte nur in ausnahmesituationen durchgeführt werden) in der position “1” des drehknopfes des gewichtsaus- gleiches, der sog. Grundstellung, sind 4 gewichtsaus- gleichsfedern fest im eingri...

  • Page 11

    - 7 - video 60 plus efp bedienungsanleitung ➪ ➪ bringen sie nun die balanceplatte wieder in die ausgangsposition ➪ ➪ sichern sie die balanceplatte mit dem klemmhebel ➪ ➪ Öffnen sie die aufbau-arretierung 3.6.2 bitte beachten sie: hydroköpfe neuerer bauart (ab dem jahr 2000) verfügen über eine balanc...

  • Page 12: Technische Daten

    Bedienungsanleitung video 60 plus efp - 8 - 3.8 bremsen die horizontalbremse löst die klemmung für horizontale und die vertikalbremse für vertikale schwenks. Beide bremsen können während der aufnahme vibrationsfrei mit einer hand betätigt werden. 3.9 sucherlupenstütze der video 60 plus efp hat an se...

  • Page 13: Das Baukastensystem

    - 9 - video 60 plus efp bedienungsanleitung 4.2 abmessungen 124 mm 200 mm 220 mm 76,5 mm 5 das baukastensystem die video 60 plus efp köpfe sind modular aufgebaut. Nachfolgend beschriebene modifikationen können selber durch- geführt werden. Um längere umbauzeiten zu vermeiden, ist - wenn nicht anders...

  • Page 14

    Bedienungsanleitung video 60 plus efp - 10 - 5.1 umbau des video 60 plus efp auf v-förmige keilplatte mittels inbusschlüssel #2 lösen sie die 2 schrauben der spindelfixierung und entnehmen das fixierklötzchen. Lösen die klemmung der balanceplatte (roten hebel unter- halb der balanceplatte nach links...

  • Page 15

    - 11 - video 60 plus efp bedienungsanleitung zubehörprogramm ein und fixieren diese zuerst mit den beiden fixierstiften. Dann werden die vier inbusschrauben eingesetzt und hand- fest angezogen. Sie können nun andere schwenkarme verwenden. 5.3 umbau des video 60 plus efp auf flachboden stellen sie de...

  • Page 16: Zubehör

    Bedienungsanleitung video 60 plus efp - 12 - 6 zubehör teile aus dem sachtler zubehörprogramm in der reihenfolge ihrer erwähnung: 7 garantie der garantieanspruch erlischt, wenn ➪ der hydrokopf unsachgemäß und außerhalb der spezifizier- ten technischen daten betrieben wurde oder ➪ das grundgehäuse vo...

  • Page 17: Safety Instructions

    - 13 - video 60 plus efp manual 1 safety instructions ➪ when the camera is mounted, the clamping screw of the video 60 plus efp must only be released if camera and tri- pod are secured against falling over. ➪ when placing the camera plate into the video 60 plus efp, make sure not to hold fingers wit...

  • Page 18: Operation

    Manual video 60 plus efp - 14 - vertical brake tilt safety lock vertical setting of fluid damping locking lever of touch & go system lever for ½ counterbalance spring battery holder of touch bubble spindle of sliding balance plate 3 operation 3.1 levelling of the fluid head the video 60 plus efp has...

  • Page 19

    - 15 - video 60 plus efp manual 3.2 removing of the camera plate the video 60 plus efp comes with a touch & go quick release plate. ➪ hold the camera plate with one hand. ➪ grasp the locking lever with your thumb and index and pull down the red safety button. ➪ move the locking lever as far as possi...

  • Page 20

    Manual video 60 plus efp - 16 - make sure that the tilt safety lock has engaged (the head can’t be tilted any more). ➪ hold the camera with one hand. ➪ grasp the locking lever with your thumb and index and pull down the red safety button. ➪ move the locking lever as far as possible to the left and t...

  • Page 21

    - 17 - video 60 plus efp manual 3.6 adjusting the camera’s counterbalance ➪ hold the camera by securing the pan bar. ➪ turn the counterbalance knob to that number which best compensates for the weight of the camera. ➪ after each spring is released, check if the camera will remain in a tilted positio...

  • Page 22

    Manual video 60 plus efp - 18 - ➪ ➪ keep on turning the knob of the spindle to the left until the balance plate is in the very rearmost positi- on you will see 4 tiny holes in the base plate above the 4 counterbalance fixing points (only from serial no. 60300 upwards) ➪ ➪ you may now screw in (incre...

  • Page 23

    - 19 - video 60 plus efp manual ➪ ➪ having heard the balance plate snapping in you carefully open the tilt safety lock ➪ ➪ fine adjustment can now be performed via the spind- le drive ➪ ➪ last but not least you apply the lock of the balance plate again 3.7 setting of the damping the video 60 plus ef...

  • Page 24: 4. Technical Specifications

    Manual video 60 plus efp - 20 - 4. Technical specifications 4.1 general data tripod / pedestal fitting: camera fitting: max. Load: weight: batteries: pan arms: tilt angle: grades of drag: balance plate: counterbalance: temperature range: panning range: +90 ° / -75 ° horizontally and vertically 9 eac...

  • Page 25: The Modular System

    - 21 - video 60 plus efp manual 5 the modular system due to the video 60 plus efp fluid heads modular design you may perform certain modifications yourself. In order to safe time you can do all work with an allen wrench #4 unless otherwise specified. The following modifications can be performed: ➪ c...

  • Page 26

    Manual video 60 plus efp - 22 - turn the spindle to the right until you can see it coming out at the front of the head. Place the fixation screw in the spindles top end and tighten it. The spindle is now fastened. The conversion is done. 5.2 conversion of pan bars and rosette open the 4 screws of th...

  • Page 27: Accessories

    - 23 - video 60 plus efp manual next to the centre bolt you will see 4 allen screws. Those have to be unscrewed and the whole piece has to be removed. Take he mitchell adapter piece with locking knob from the sachtler accessory range. Place the adapter piece into the recess at the bottom side of the...

  • Page 28: Warranty

    Manual video 60 plus efp - 24 - 7 warranty warranty expires if: ➪ the fluid head was operated improperly or not in line with the specified technical data, or ➪ the head housing was opened by unauthorised personnel. We reserve the right to make changes based on technical advances..