Saeco Easy Operating Instructions Manual - page 6
6
INSTALLATION / PRIMING
The machine is warming
up; the light is fl ashing.
Note: Prime the machine during initial set up, if the
machine has not been used for several days, after
refi lling the water tank, or any time the priming indi-
cator is steadily lit:
Turn the knob countercloc-
kwise to start priming the
machine.
Fill the tank with fresh
water.
Move the ON/OFF switch to
“I” to turn on the machine.
Fill the coffee bean container
with coffee beans.
Check that all components
are correctly placed.
Place a container under
the steam wand.
Wait until a steady stream
of water fl ows out from the
nozzle.
Turn the knob clockwise to
stop the priming process.
Remove the container.
See rating plate
Check the dater on “Aqua Prima” fi lter; if fi lter is past its
date, replace it with a new one.
The “Aqua Prima” fi lter can
be installed (see pg.13).
(Optional; it can be purcha-
sed separately).
The messages displayed by the machine during operation are shown
on page 14.
Important warning for using the “Aqua Prima Filter” can be found at
page 14.
Connect the plug placed at
the opposite side of the ca-
ble to an adequate socket.
When the indicator lights
are fi xed, the machine is
ready for use.
Put the plug into the soc-
ket placed on the machine
rear.
Flashing
Steadily lit