Picobaristo hd8924 en user manual de benutzerhandbuch es manual del usuario fr mode d’emploi it manuale utente nl gebruiksaanwijzing 4219.460.3607.1 hd8924 saeco_picobaristo amf_we_cover_a5_fc.Indd 1 01-09-16 15:24.
Espresso espresso lungo caffe crema aroma strength menu / special drinks hot water milk froth 2 1 3 4 14 13 12 16 33 31 29 34 18 19 17 25 26 32 35 21 20 30 28 27 24 22 23 5 6 7 9 8 10 11 36 38 41 40 42 39 37 15.
Contents machine overview_________________________________________________________________ 6 introduction ______________________________________________________________________ 6 first installation___________________________________________________________________ 7 aquaclean filter ________________...
Machine overview 1 user interface 22 service door 2 espresso button 23 'drip tray full' indicator 3 espresso lungo button 24 drip tray 4 caffÈ crema button 25 drip tray release button 5 escape button 26 cord 6 ok button 27 grind setting knob 7 standby button 28 cover of bean hopper 8 display 29 bean...
- this is the qr code. Scan this code to access instruction videos on how to brew the best coffees, how to clean the machine and for a list of frequently asked questions. (www.Saeco.Com/care) - the separate booklet with important safety information. First installation for first installation, follow ...
2 press the menu/special drinks button, select menu and press the ok button to confirm. Scroll to select aquaclean filter. Press the ok button to confirm. Aquaclean filter 0 / 8 - the display shows the number of aquaclean filters that have been installed previously from 0 to 8 filters. Activate aqua...
Replacing the aquaclean filter note: replace the aquaclean filter as soon as the capacity has dropped to 0% and the filter icon flashes quickly. Replace the aquaclean filter at least every 3 months, even if the machine has has not yet indicated that replacement is required. Tip: we advise you to buy...
Number of red squares value to be set water hardness 1 very soft water 2 soft water 3 hard water 4 very hard water 4 press the menu button, select menu and scroll to select water hardness. Select the preferred water hardness setting and press the ok button to confirm. Control panel and display this ...
- stand-by time: this is the time after which the machine goes into standby mode. - water hardness: to be able to adjust the machine settings to the water in your region, please measure the water hardness. - to activate the aquaclean filter - to start descaling aroma strength button use the aroma st...
Frothing milk warning: danger of scalding! Dispensing may be preceded by small jets of hot water. Use the appropriate protective handle only. Note: use cold milk (at a temperature of approximately 5°c/41°f) with a protein content of at least 3% to ensure an optimal frothing result. You can use whole...
Hot water warning: danger of scalding. Only grab the steam wand by its protective handle. Dispensing may be preceded by small jets of hot water. 1 remove the automatic milk frother from the hot water/steam dispensing spout. 2 place a container under the hot water/steam dispensing spout and press the...
Beverage lengths beverage name standard length length range espresso 40 ml 20 - 230 ml ristretto 30 ml 20 - 230 ml espresso lungo 80 ml 20 - 230 ml caffè crema 125 ml 20 - 230 ml espresso double 60 ml (double grinding) 40 - 230 ml hot water 300 ml 50 - 450 ml adjusting volume and taste adjusting cof...
1 2 3 4 5 1 very mild 2 mild 3 regular 4 strong 5 very strong note: the machine automatically dispenses the correct coffee volume for each coffee strength. Note: you can also use the aroma strength button to brew coffee with pre-ground coffee. Note: after adjusting the coffee strength, the display s...
Cleaning table part description when to clean how to clean brew group weekly remove the brew group and clean it under the tap (see 'cleaning the brew group under the tap'). Depending on the type of usage lubricate the brew group (see 'lubrication'). Monthly clean the brew group with the coffee oil r...
Cleaning the brew group under the tap 1 switch off the machine and unplug it. 2 remove the drip tray with the coffee grounds container. 3 open the service door. 2 1 4 press the push button (1) and pull at the grip of the brew group to remove it from the machine (2). 5 rinse the brew group thoroughly...
1 before you slide the brew group back into the machine, make sure the two yellow reference signs on the side match. If they do not match, perform the following step: - make sure the lever is in contact with the base of the brew group. 2 make sure that the yellow locking hook of the brew group is in...
3 apply a thin layer of grease around the shaft in the bottom of the brew group. 4 apply a thin layer of grease to the rails on both sides (see figure). 5 reinsert the brew group (see 'reinserting the brew group'). You can use the grease tube multiple times. Cleaning the automatic milk frother quick...
6 rinse the jug with fresh water and fill it with half a liter of fresh water for the rinsing cycle. Empty the container and place it back under the automatic milk frother. 7 insert the suction tube into the jug. 8 press the milk froth button. 9 you can press ok to stop or let the machine dispense u...
The display, the machine will eventually stop working properly. In this case, repairs are not covered by the warranty. Only use saeco descaling solution to descale the machine. Saeco descaling solution is designed to ensure optimal performance of the machine. The use of other products may damage the...
Max calc clean calc clean 1 2 10 fill the water tank with fresh water up to the calc clean level indication. Place the water tank back into the machine and press ok. 11 remove and rinse the milk carafe. Fill the milk carafe with water up to the min level indication. Insert the milk carafe into the m...
Warning icons and error codes meaning of the warning icons add water fill the water tank with fresh water to the max level indication. The coffee grounds container is full. Make sure the machine is switched on. Then remove and empty the coffee grounds container. Add coffee the bean hopper is empty. ...
Error code problem cause possible solution 05 there is a water circuit problem. There is air in the water circuit. Remove and place back the water tank a couple of times. Make sure you insert it into the machine properly. Check if the water tank compartment is clean. If you use an aquaclean filter: ...
Problem cause solution the 'coffee grounds container full' icon remains displayed. You emptied the coffee grounds container while the machine was switched off. Always empty the coffee grounds container while the machine is switched on. If you empty the coffee grounds container when the machine is sw...
Problem cause solution the coffee is not hot enough. The cups you use are cold. Preheat the cups by rinsing them with hot water. The temperature is set too low. Check the menu settings. Set the temperature to 'high' in the menu. You added milk. Whether the milk you add is warm or cold, it always dec...
Problem cause solution i cannot activate the aquaclean filter and the machine asks for descaling. You have already replaced the aquaclean filter 8 times. After you have replaced the aquaclean filter 8 times, you need to descale the machine. Descale your machine first and install the aquaclean filter...
Problem cause solution there is water under the machine. The drip tray is too full and has overflowed. Empty the drip tray when the 'drip tray full' indicator pops up through the drip tray. Always empty the drip tray before you start descaling the machine. The machine is not placed on a horizontal s...
Start descaling? 23 min.
4219.460.3607.1 (9/2016) www.Saeco.Com/care >75% recycled paper >75% papier recyclé.
