SAF CFOL Series User Manual - 2. Configuration
User Guide
2. Configuration
2.1 Network
The network configuration as described below is required for point-to-point management
purposes. Use the
Configuration|Network menu to setup network settings of the point-to-point unit:
Method - specify IP configuration mode:
Static IP - choose to specify static IP of the device.
Dynamic IP - choose to use dynamic IP given by the DHCP server (running DHCP
server is required).
IP address - specify the device IP address [digit and dots]. When shipped from the
factory or reset to factory settings, device defaults to a static IP address of
192.168.2.66.
Subnet mask - specify the device subnet mask [digit and dots]. When shipped from the
factory or reset to factory settings, the device defaults to a subnet mask of
255.255.255.0.
Default gateway - specify the IP address of the device gateway [digit and dots]. When
shipped from the factory or reset to factory settings, the device defaults to a gateway IP
address of 192.168.2.1.
DNS server 1 - specify the IP address of the primary DNS server [digit and dots]. The
DNS (Domain Name Service) service translates Internet host names into their IP
addresses.
DNS server 2 - specify the IP address of the secondary DNS server.
Ethernet configuration - configures the Ethernet link speed and the duplex mode of
the Ethernet port. Choose "auto" for automatic detection of link speed and duplex mode.
VLAN ID - specify the management VLAN ID [2-4094].If a management VLAN is
enabled, all traffic received by the device must by tagged with the management VLAN ID
to access the network. All non-tagged traffic will be dropped, thus reducing the risk of
unauthorized access.
“CFOL Series”, User Guide
© SAF Tehnika A/S 2009
12