Safco 1851 Assembly Instructions - page 3
1851-37: 3 of 4; Rev. 3; 09/06
Safco Products Company, New Hope, MN 55428
FRONT
Q
Insert one dowel end of the N Kick Panel into the
Left Side Panel in the holes furthest from the Back
Panel.
4
Push the two P Swivel Casters with Brakes
into the sockets of the Caster Brackets at
the front of the unit. Push the two Q
Swivel Casters without Brakes into the
Caster Brackets near the back side of the
unit.
6
Lift the C Right Side Panel over the assembled
panels. Align the Screw Posts with the correspond-
ing holes on the Back Panel, Bottom Panel and
Fixed Shelf (also guide the Wood Dowels on the
Kick Panel into the holes in the side panel), then
fasten by turning each of the eight cams CLOCK-
WISE as far as they can turn.
5
U RIGHT DOOR PANEL
NOT SHOWN
LEFT
SIDE
PANEL
T
Use a soft hammer or mallet to tap the R Hinges into the
recesses on the T Left Door Panel. Use the pre-installed
screws to fasten the S Hinge Mount Plates into the pre-drilled
holes on the Left Side Panel. If the Hinge and Mount came in
separate pieces, bend the arms of the Hinges and insert the
slots of the arms over the Hinge Mount Plate set screws. Adjust
door position and tighten the set screws. Turn
the unit onto its right side, and repeat with the
U Right Door Panel.
7
R
ARM
SLOT
SET
SCREW
TIGHTEN
SET
SCREW
P
R
S
R
S
N
C
FRONT