Safco 1851 Assembly Instructions - page 4
1851-37: 4 of 4; Rev. 3; 09/06
Safco Products Company, New Hope, MN 55428
With two people, carefully stand the unit upright.
Fasten one V Handle to the outer side of the Left
Door Panel using two W Long Screws. Fasten
the other Door Handle to the outer side of the
Right Door Panel with two more Long Screws.
If necessary, center the Door Panels by adjusting
the set screws on the Door Hinges as needed.
8
Lower the E Top Panel down onto the side panels
and divider. Guide the Dowels in the Divider into the
center holes in the Top Panel, and guide the Screw
Posts into the holes on the upper edges of the side
panels. Fasten by turning each of the four cams
CLOCKWISE until they stop.
10
V
W
E
Position the X Divider with the finished edge toward
the front of the unit, and insert the dowels into the
holes in the center of the F Fixed Shelf.
9
Insert Y Shelf Pegs into the small holes in both
compartments in the configuration you desire using
four pegs per shelf. Place Z Small Shelves onto the
Shelf Pegs.
Prevent the assembled unit from rolling by activating
the brakes on the Swivel Casters with Brakes.
11
Z
Y
V
X
F
BRAKES
FRONT;
FINISHED EDGE