Safco 8962 Assembly Instructions

Summary of 8962

  • Page 1

    Left side panel 1 8962-02 right side panel 1 8962-03 screw post 18 hffmfb locking cam 18 hffmfc small screw, 1/2”l 41 3695-28 left cabinet rail 1 1905-15 right cabinet rail 1 1905-16 half-shelf 1 8962-07 back panel 1 8962-04 bottom panel 1 8962-05 swivel caster 2 8918-25 screw, 5/8”l 16 8918-22 swiv...

  • Page 2

    Lay out the h half-shelf and the i back panel with the large holes facing up, and the j bottom panel with the side that has only four holes facing up. Insert d locking cams into the large holes in the back panel and half-shelf with the arrows pointing toward the nearest side edge. Insert four c scre...

  • Page 3

    Carefully lay the unit on its left side. Using a soft hammer or mallet, tap the n hinges into the recesses on the o left door panel. Use the pre-installed screws to fasten the p hinge mount plates into the pre-drilled holes on the left panel. If the hinge and mount came in separate pieces, bend the ...

  • Page 4

    Install the drawer: lift the back rollers on the drawer rails over the front rollers on the cabinet rails, tilt the drawer enough to start the drawer moving, and lower the drawer to push it all the way into place. 8962-37: 4 of 4; rev. 1; 05/07 safco products company, new hope, mn 55428 lay the v to...