Safco 8962 Assembly Instructions - page 4
Install the drawer: lift the back rollers on the Drawer
Rails over the front rollers on the Cabinet Rails, tilt
the drawer enough to start the drawer moving, and
lower the drawer to push it all the way into place.
8962-37: 4 of 4; Rev. 1; 05/07
Safco Products Company, New Hope, MN 55428
Lay the V Top Panel down with the holes
facing up. Place the W Drop Leaves at each
end, also with the holes facing up, as shown in
the illustration. Attach a X Piano Hinge to
each joint between Drop Leaf and Top Panel,
using eight E Small Screws per Hinge.
Add four C Screw Posts to the Top Panel,
one near each corner.
Screw the Y Drop Leaf Hinges into place as
shown, making sure the LONG arm of the
Hinge faces the center of the Top Panel. Use
two E Small Screws per Hinge.
9
With two people, carefully lift and turn the Top
Panel assembly over the Left and Right Side
Panels, and guide the Screw Posts into their
proper holes. Secure by locking the Cams,
as before.
Attach the free end of each Drop Leaf Hinge
to its Side Panel, using E Small Screws.
10
With the special Z Drawer Screws, fasten one
of the AA Drawer Sides to the BB Drawer
Back and the CC Inner Drawer Front, making
sure all grooves face the drawer center.
Carefully slide the DD Drawer Bottom into the
grooves.
11
V
W
X
W
Y
E
C
E
Now fasten the other AA Drawer Side, with Z
Drawer Screws.
12
Attach the EE Outer Drawer Front to the drawer by
inserting FF Handle Screws through the inner Drawer
Front, the Outer Drawer Front, and into the GG
Handles (use the OUTER sets of holes). Tighten
securely. Attach the HH Left Drawer Rail and the I I
Right Drawer Rail to the drawer, with the rollers
toward the back, using three E Small Screws each.
13
14
GROOVES
Z
AA
BB
CC
DD
HOLES
NO
HOLES
Z
AA
EE
FF
HH
I I
E
ROLLER