SAFE HOME WS209 User Manual - Www.Safehome.Dk
www.safehome.dk
6
3. Replacing the batteries
Always use alkaline batteries as replacements because any other battery can cause prob-
lems. Typical life of batteries is two years.
Ensure the correct steps are taken when changing batteries:
• Switch off the tamper protection by pressing
buttons simultaneously for 2 seconds.
The siren is now off for 1 hour.
• Remove the siren box cover and switch off the siren power.
• Remove the used batteries and replace them with 4 x fresh alkaline ‘D’ cells.
• Switch on the siren power and check that the siren beeps and flashes.
• Fix the siren cover with the securing screw.
• Press the
button at the same time for 2 seconds to exit change battery
mode and to activate the siren (All blue light will OFF and the Red light will start
blinking slowly). Your siren is now activated.
4. Setting the system house code
You can change the house security code on each sensor, smart panel and other modules
of your security system to avoid interference with other systems.
In most cases you will NOT need to change the factory settings of the house security
code. If the Smart Panel and sensors activate intermittently or do not work at all, you
may be able to solve the problem by changing the house security codes on all system
modules.
There are 4 jumpers/dip-switches on each device. Remove the battery compartment
cover, then pull out the Jumper to change the house security code setting and make sure
the jumpers on the Smart Panel, sensors and remotes match exactly.
Jumpers for
house security
code
• Smart Panel
Default house code:
1: ON, 2: ON, 3: ON, 4:ON
*Jumper: ON = Plugged, OFF = Pull Out
Dip-Switches for
house security
code
• Siren
Default code:
1: ON, 2: ON, 3: ON, 4: ON