SafeGuard Go BOOSTER Instruction Manual - Harness
P
• If the child restraint does not remain
securely attached, repeat steps
1-10 or move the child restraint to
another seating location.
• If possible, move unused vehicle
seat belts out of the child’s reach to
avoid a strangulation hazard.
• Check for a secure installation
before every use of the child
restraint!
Removal:
• To remove the tether, press the
tether adjuster button and loosen
the tether strap.
O
Depress the
snap and remove the hook from the
vehicle tether anchor.
P
• Roll or fold excess tether strap and
attach Velcro
®
strip to prevent
tangling.
• Fold harness to access vehicle belt.
Unbuckle vehicle seat belt and
remove from vehicle belt attachment
loops.
Q
O
Q
34
After installation is complete,
see page 44,
Securing
Child in Harness.
HARNESS
M
OD
E
35
A
Lap-Shoulder Belt cont’d.
Installation With Vehicle Seat Belts
(30-60 Pounds, 34” - 52”)
WARNING
FAILURE TO FOLLOW ALL INSTRUCTIONS MAY RESULT IN SERIOUS
INJURY OR DEATH.
• Use this child restraint FORWARD FACING ONLY.
• This child restraint requires the use of the tether. IF a tether anchor is not
available, DO NOT USE this child restraint.
• Read and follow all instructions in the child restraint instruction manual
and the vehicle owner’s manual. In the case of a discrepancy, follow the
instructions in the vehicle owner’s manual.
• See pages 17-20 for important vehicle seat belt requirements.
• Always store LATCH connectors in their storage location on side of child
restraint when not in use.
Installation With Lap Only Belt
1. Choose an appropriate vehicle
seat and verify a tether anchor is
available.
A
• Refer to vehicle owner’s manual to
determine the exact tether anchor
location.
• If a tether anchor is not available,
do NOT use this child restraint.