Safeline MX2 Installation Manual - page 15
15
© 2010 SafeLine and all the SafeLine products and accessories are copyrighted by law.
Programming
ENGLISH V. 4.02
DISTRESS MESSAGE
CODE
DATA
COMMENTS
Record distress message played
in the lift car.
*51*
”Speak” #
This message will be played in the lift cabin when the emergency lift
telephone starts calling the alarm centre. Make sure that there is no
noice in the background when recording the message.
Example of message:
Please do not panic, the emergency telephone
is now calling the emergency call centre.
Record alarm message from Lift
Car to alarm central
*52*
”Speak” #
This message will be played to the alarm receiver and in the car when
the call is answered. Make sure that there is no noice in the background
when recording the message.
Example of message:
This is an alarm from the lift on 5th avenue.
To hear the this message again, press “1”. To terminate the call, press
“#” before hanging up.
Options for the recorded distress
message
*61*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*61*
#
Play the the recorded message.
Options for the recorded message
from lift car
*62*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*62*
#
Play the the recorded message.
OTHER CODES
CODE
DATA
COMMENTS
Emergency signal in speaker
*71*
- #
The speaker siren will sound at emergency call.
1 = On (Default)
0 = Off
Ring tone timeout
*72*
- - #
Number of ring signals before dialling the next number.
Additional input function
*73*
- #
Selects input function:
0 = None (Default)
1 = Filter, blocks the alarm input when active.
2 = LMS(Lift Monitoring System), sends a lift monitoring alarm at input
activation.
3 = Clear/Maintenance
Additional input type
*74*
- #
0 = Normally-open contact, NO (Default)
1 = Normally-closed contact, NC
Hot Line
*75*
- #
Phone connects directly to a fi xed receipient without dialling a phone
number
0 = Standard phone line (Default)
1 = Hotline
Compatability mode
*77*
- #
0 = The call is automatically validated when there is a voice response.
The call is disconnected by pressing #.
1 = Kone “EC2” (lift telephone): The call is validated by pressing “4”. The
call is terminated without receipt notifi cation by pressing “2” (the unit will
dial the next number). The call is terminated by pressing ”0”.
2 = Manual answering mode: The call is validated by pressing “4”. The
call is terminated by pressing “#”.
Indicator mode
*78*
- #
0 = Standard
1 = Strictly EN81-28
Voice communication time-out
*79*
- #
1 - 20 minutes. Standard = 8 min
Reset active alarm automatically
*80*
#
0 = OFF,
1 = ON (Default)
Auto answer
*81*
- - #
No of signals before SafeLine answers incoming call.
Can be set from 00-16. 00=no answer. (Default = 02)
Unit number
*82*
- #
Program Unit number 1-9 (Default = 0)