Safeline MX3 Installation Manual - page 18
18
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Confi guration
DISTRESS MESSAGE
CODE
DATA
COMMENTS
Record distress message played
in the lift car.
*51*
”Speak” #
This message will be played in the lift car when the emergency lift
telephone starts calling the alarm receiving centre. Make sure that there
is no noise in the background when recording the message.
Example of message:
Please do not panic, the emergency telephone
is now calling the emergency call centre.
Record alarm message from Lift
Car to alarm central
*52*
”Speak” #
This message will be played to the alarm receiver and in the car
when the call is answered. Make sure that there is no noise in the
background when recording the message.
Example of message:
This is an alarm from the lift on 5th avenue.
To hear this message again, press “1”. To terminate the call, press “#”
before hanging up.
Options for the recorded distress
message
*61*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*61*
#
Play the the recorded message.
Options for the recorded message
from lift car
*62*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*62*
#
Play the the recorded message.
OTHER CODES
CODE
DATA
COMMENTS
Emergency signal in speaker
*71*
- #
The speaker siren will sound at emergency call.
1 = On
0 = Off (Default)
Ring tone timeout
*72*
- - #
Number of ring signals before dialling the next number (8 by default).
Additional input function
*73*
- #
Selects input function:
0 = None (Default)
1 = Filter, blocks the alarm input when active.
2 = LMS (Lift Monitoring System), sends a lift monitoring alarm at input
activation.
3 = Clear/Maintenance
4 = Call Delay
Additional input type
*74*
- #
0 = Normally-open contact, NO (Default)
1 = Normally-closed contact, NC
Hot Line
*75*
- #
Phone connects directly to a fi xed receipient without dialling a phone
number.
0 = Standard phone line (Default)
1 = Hotline
Volume control
*76*
- #
Adjustabel volume, between 1-6.
(Default = 4)