Safeline Sit'n'Stroll Instruction Manual - In The Vehicle
4.
Thread the locking clip onto both belts , placing it as close to the
latch plate as possible.
5.
Buckle the belt again. It may be necessary to press the Sit’n’Stroll
™
into the auto seat cushion to get it buckled.
6.
Secure the top tether to the tether anchor in the vehicle if desired.
7.
Be sure the back of the Sit’n’Stroll
™
is at a 45-degree angle. The
base of the seat should be horizontal. Use a tightly rolled towel or
sheet (or the top tether if it is being used) to adjust the angle of the
seat if necessary.
8.
Lift up on the Sit’n’Stroll
™
to check that it is securely tightened. The
belt should be tight around the restraint. If it is not, remove the
locking clip and repeat steps 1-6. If you have tightened the belt and
it is still not secure, move it to another seating location and repeat
steps 1-7. If there is no location in your vehicle that will securely
hold the restraint, do not use it! Contact your vehicle dealer to have
a vehicle belt installed that will remain tight.
Installing the Sit’n’Stroll
™
in the Vehicle
Forward-Facing
The Sit’n’Stroll
™
is equipped with two belt paths for use forward facing. The path
best suited for your child is determined by their height and weight.
If your child is taller than 33 inches and weighs over 28 pounds, the vehicle
seat belt should be secured in the upper forward-facing vehicle belt path.
If your child is under 33 inches and weighs less than 28 pounds, the vehicle
seat belt should be secured in the lower forward-facing vehicle belt path.
Use the vehicle belt path based upon your child’s height and weight.
If, after installing the Sit’n’Stroll
™
, it is not tight enough,
move it to another seating location. If it still cannot be
secured tightly, contact your vehicle dealer and request
that a manual seat belt system be installed.
15