Safeline Sit'n'Stroll Instruction Manual - T I P S
The Sit’n’Stroll™ is designed to be converted from car seat to
stroller and back again while holding the child, still secured in the
Sit’n’Stroll™, OFF THE GROUND. If the Sit’n’Stroll™ is converted on
the ground, the mechanism may jam.
T i p s
T i p s
The Sit’n’Stroll™ is to be used only by one child at a
time. Never place more than one child in the seat.
Until you are well practiced in following these
instructions, do not attempt to convert from car seat
to stroller or vice/versa with your child in the seat.
Always secure your child using the Sit’n’Stroll™’s
5-point harness system.
Individuals with a history of back trouble are advised
to excercise caution or refrain from quick movement
when converting the Sit’n’Stroll with a child in it. Do
not attempt to convert the unit if you are at risk of back
injury.
Excess weight placed in the storage bin may cause
a hazardous unstable condition. The manufacturer
recommends not to exceed 10 pounds. Parcels or
accessory items or both placed on the unit may
cause the unit to become unstable.
2.
When the slider stops, relax your finger
pressure on the red lock release and allow it
to latch securely in its lowest position. Pull up
on the grip without squeezing the red lock
release to ensure the wheels are locked.
Place the Sit’n’Stroll™ on the ground.
W A R N I N G
1.
Place one hand in the handle slot located
between your infant’s feet. With your other
hand, grasp the slider grip located on the back
of the Sit’n’Stroll™. Gripping both handles
securely, remove the Sit’n’Stroll™ from your
vehicle. Squeeze the red lock release evenly
with your fingers and move the slider grip
down. This deploys the wheels.
Slider
Grip
Handle
Slot
22