SAFERA Smart R Stove Guard Installation manual - page 13
13
3. InstallatIon troublEshootInG
problem
Remedy
Installation is not proceeding as
expected.
You can re-start the installation process anytime
by pressing the adjustment mode button
❽forfive
seconds until you hear the signal and continue from
step 3/6.
the central unit
Ⓐ is not respond-
ing to any button and none of the
indicator lights are lit.
Ensure that the power supply
Ⓓ is connected cor-
rectly to the wall socket and that the socket has
power.
none of the cooker plates cause a
child proof lock alarm.
the wireless connection has not been properly
made: redo the installation starting from step 3/6.
the appliance turns off the power
from the cooker, but the power
comes back on immediately.
make sure that the Power Control unit
Ⓒ is con-
nected correctly – in other words, the cooker is
connected to the out cable.
If the indicator light for service
need
❾ is constantly lit, the appli-
ance is faulty:
Press the oK but-
ton
❷tofindoutthe
problem type by the
indicator lights (see
on the right).
Blinks once: Problem with the
radio connection to the Power
Control unit
Ⓒ.
Blinks twice: Power Control unit
Ⓒ malfunction.
Blinks three times: Power Control
unit
Ⓒ overheated.
Blinks once: sensor malfunction.
Blinks twice: the service cycle
of the extinguisher unit
Ⓔ is full.
Please contact your vendor or saF-
Era product support.
Blinks three times: Power supply
Ⓓ malfunction.
Blinks once: the extinguisher unit
Ⓔ is triggered and needs to be re-
placed. Please contact your vendor
or saFEra product support.
Blinks twice: the connection of the
extinguisher unit
Ⓔ is faulty.