Safety 1st onBoard 22 Instructions Manual - page 23
Check for Proper
Recline
Make sure level line on side
of child restraint is level with
the ground. Adjust base if
needed. (See section C-2).
You may need to place a large
rolled towel(s) or foam pool
noodle(s) under the front of the
base to achieve correct recline
angle. Check often to be sure
padding is still in place and
the belt is tight.
DO NOT add a towel or pool noodle while the
recline foot is being used.
To Remove LATCH Belt
From Vehicle Anchor
Remove child restraint from
base. Press down firmly on
the base on the side with
the LATCH adjuster. Press
release button to release tension. Unhook LATCH from bar
by squeezing spring lever and twist hook.
7.
8.
E. Installing Rear-Facing
43
44
Pull up on both left and right
corners at the foot end to
make sure the child restraint
is locked to the base.
The carrying handle can be
in any locked position when
installed in the vehicle.
Failure to securely attach child restraint to base
can result in serious injury or death.
E-4 Installing Base with Vehicle
Belts
Store LATCH Belts
You MUST store the LATCH
system when using the
vehicle seat belts. See
section D-7.
1.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Store LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
Place Base in Vehicle
Rear-Facing
Center the base in the
chosen seating position.
2.
Thread Vehicle Belt
Thread the vehicle lap
or lap/shoulder belt
combination through belt
path as shown.
With an ALR belt, pull the
belt all the way out before
threading the base.
3.
continued on next page.
4358-6459A SF Onboard 22.indd 45-46
4358-6459A SF Onboard 22.indd 45-46
9/5/14 4:27 PM
9/5/14 4:27 PM