Safety 1st onBoard 22 Instructions Manual - page 25
47
48
Lap Belt
Lap/Shoulder Belt
E-5 Rear-Facing Installation without Base
E. Installing Rear-Facing
4-22 lbs. (1.8-10 kg) and whose height is 29 inches
(74 cm) or less.
NOTE: If your child does not meet the criteria for the Rear-
Facing position, do not use this child restraint.
Never place a child rear-facing in a
seating position with an active frontal
airbag. This can result in serious injury
or death.
Check the vehicle belt before each use. Use
only if the belt is tightened properly and
securely.
This child restraint must always face the rear
of the vehicle when installed.
Failure to follow these warnings can result in
serious injury or death.
Thread Vehicle Belt
Thread vehicle lap belt only
through the belt path (as
shown). Buckle the vehicle
belt.
2.
Tighten Vehicle Belt
Lay your forearm across
child restraint at the belt
path while pulling up on belt
to tighten. With an ALR belt,
pull the belt all the way out
before tightening. Feed the
slack back into the retractor
while tightening.
3.
Place Child Restraint in
Vehicle Rear-Facing
Center the child restraint
in the chosen seating
position.
Check the level to ground
line to see if it is level
with the ground. Adjust if
needed.
NOTE: The carrying handle
can be in any locked
position when installed in
the vehicle.
1.
E-6 Installing Child Restraint with
Vehicle Belts
4358-6459A SF Onboard 22.indd 49-50
4358-6459A SF Onboard 22.indd 49-50
9/5/14 4:27 PM
9/5/14 4:27 PM