Instruction manual revised: september 13th, 2013 sb-cvr4000 front back camera microphone on/off record mode switch v - video p - picture.
Before you start before you use your cross dvr you will do the following: • plug your dvr into your pc • charge it fully • download time files from www.Safetybasement.Com • set your timestamp on the dvr connect your cross to pc use the included usb cable. Connect one end to the usb port in your pen....
Connect your cross dvr to when you connect your dvr, on many windows computers, a pop up window will appear called autoplay. This is normal. Just choose open folder as shown. Your dvr will appear as an external or removable drive with a drive letter, such as e:. Your letter may vary. You will see vi...
Download files go to the same section you downloaded this user manual right-click on the settingtimetool file, and choose save link as, or save target as... Save the file to your dvr, as shown in this example. In the same areas as the folders once you have saved this file there, double click it, in ...
Recording video • before turning unit on, make sure the mode switch is set to v (for video). Power on & start recording video - press and release the power button. An orange light will come on then settle on a steady blue. You are now recording video. To stop video recording just press and release t...
Taking picture • before turning unit on, make sure the mode switch is set to p (for picture). Power on & start recording video - press and release the power button. A blue steady light will come on. You are now in picture standby mode. Press and release the power button. An orange light should blink...
Device specifications resolution 640 x 480 memory type onboard flash memory storage 8 gb frame rate 30fps video photo quality wav dimensions 1280x960 pixels bit depth 24 size (approx) 92 kb photo audio format wav audio ebit rate 128 kbps channels 1 (mono) audio sample rate 8 khz audio.
