Ucit live hd 4 camera dvr installation manual 04/17 version 1.0
This is a step by step guide that will walk you through installing the ucit live hd 4 channel camera system. Basic wiring experience and knowledge is required at the minimum. Please follow each step , otherwise your system may not work properly. If you have any questions regarding the installation o...
Notes and precautions please make sure power connections are clear to you before you make the connection. Please follow this guide step by step do not skip around. It is normally required to have a professional installer install these units. Keep dvr system away from liquids, heavy dust and dirt, fir...
Step 1: find a suitable location to mount the dvr in such a way that is accessible to the fleet manager. (to pull sd card and for troubleshooting) the dvr can also be hidden if requested. Step 2: after unboxing the equipment, and getting acquainted with what’s included, start by plugging in accessori...
C. Plug in the accessory harness for the microphone (if applicable). Follow the steps below to ensure proper connection of the microphone: b1. - dvr find the accessory harness rca (female) white wire only c find the microphone extension yellow rca (male) and red plug (female) 1 plug the yellow rca (...
Place the microphone so that it is visible and in an optimum position to get the best clarity. Pictured right is a recommended placement example. Driver side a-pillar, this way it is near the driver. Step 3: mount the cameras as directed or as needed. Each camera is individually packaged with mounti...
Camera model: st-1231 ensure cameras are properly aimed by adjusting the 4 screws on both sides of the camera shown at the right. This camera example, as you can see, has also been mounted with 3m trim tape. The bracket attached to this camera is steel and will allow for screw mounting a a bit easie...
When it comes to the interior (non-ivr) camera there is a small grove etched into the back. (shown right) this indicates when the camera is up right and in the proper position. Etching should line up with the t in the bracket. You may need to loosen the allen/hex screw with the supplied key. (in the...
This step describes how to plug in the cameras and mounting. Which ever you prefer to do first. In most cases it is easier to mount the cameras as long as you know you will have enough cable. Note: be sure to line up the arrows on both ends of this connection otherwise the cameras won’t connect and y...
Step 7: ensure proper connection by checking the lights on the dvr. If you see lights then you have power. It may take a few seconds for lights to come on after you connect. Red = recording. Blue = gps. Orange = network. -red will consistently blink every second or so to indicate recording and writi...
