Safety Vision 45 series User Manual - Through A Switch Or Router.
17
Setting the Network Camera over a LAN
1.
Connect the camera to a PC using an Ethernet cable either directly or
through a switch or router.
2.
Ensure power is supplied to both the recorder and the camera.
3.
In a web browser, navigate to the camera’s IP address.
The default IP address is 192.168.1.64.
Enter the username and password:
Username: admin
Password: SV123456
4.
Install any plug-ins you are prompted to install.
5.
The browser may be required to restart, requiring you to login again.
Modifying the IP Address
To view and configure the camera via LAN (Local Area Network), you need to
connect the network camera in the same subnet with your PC. Then, install
the SADP software or client software to search and change the IP of network
camera. We will take modifying the IP Address via SADP software as an ex-
ample to introduce the IP address modification. Connect the camera to a PC
using an Ethernet cable either directly or through a switch or router.
1.
Run the SADP software.
2.
Select an activate device.
Note: Please refer to Section 3.2 to activate the camera if the camera is
inactive.
3.
Change the device IP address to the
same subnet with your computer by either
modifying the IP address manually or
checking the checkbox of Enable DHCP.
4.
Input the password to activate your IP
address modification. The batch IP address
modification is supported by the SADP. Please
refer to the User Manual of SADP for details.