Saffire Grill Co. SG22 NC Owner's Manual - Assembly
2. Lift off the top of the box. Then lift out the white foam padding.
3. The sides of the box are individually removable.
4. Open the grill and remove the cooking grid and discard the bubble wrap.
5. Remove the items in the bottom of the grill and set aside:
Stainless Steel Heat Shield, Ceramic Feet (3 Pcs.), Chimney Top,
Handle (Thermometer encl.) and Grate.
6. If your Saffire Grill will be setting on a combustible surface the Ceramic Feet (CF) and Stainless Steel Heat
Shield (SSHS) must be used.
7. Place the Feet and Shield in the position you would like the grill.
8. The Feet should be arranged underneath the Shield with equal spacing between them. One should be
placed directly in the center on the back side of the Shield and the other two on the left and right of the
front side. If you have the Saffire Wood Cart, place the rear foot about 1” from the back edge of the
platform.
Unpack the Grill
10. Remove the foam pads from around the perimeter of the
ceramic Fire Ring and lift it out of the grill. Set it aside. It
will be necessary to hold the Fire Ring from the inside. Fig.3
Proceed to Page 6
ASSEMBLY
(You may view the assembly video online at www.SaffireBBQ.com.)
Fig 3
Fig 3
Page 4
Ceramic Feet and Heat Shield
WARNING: If placed on a combustible-surface, such as
a wood deck, it is the owner’s responsibility to ensure
embers do not escape the grill and ignite the wood.
A non-combustible protective pad is recommended
underneath and in front of the lower air control/ash
clean out door.
p
9. The Ceramic Feet and Heat Shield may be replaced with a non-combustible slab. The slab should be a
solid stone or masonry unit. It must be at least 1
1/4
thick.
The recommended dimensions of the slab are at least 16”square or round and not over 20” on the
Saffire Wood Cart. (Fig. 2)
Fig.1A
Fig.1A
Fig.1B
Fig.1B
Fig.2
Fig.2
Unbox the Grill
1. Cut and remove the plastic bands from the box.