Sage BBL910 Instruction Booklet - Care & Cleaning
14
CaRe & CLeaNINg
CaRe & CLeaNINg
Jug and lid
In order to keep your jug clean and avoid
food drying on the blades, jug and lid,
follow the below steps as soon as possible
after use:
1. Rinse most of the ingredients off the
jug and lid.
2. Add 500ml of warm water and press
the AUTO CLEAN button. If thick
or sticky ingredients require extra
cleaning power add a few drops of dish
liquid detergent.
3. Rinse the jug and lid again and/or wash
separately in warm soapy water with a
soft cloth or bottle brush.
Sanitizing
The recommended sanitizing solution is
1.5 tsp (7.5ml) of household bleach in 2qt
(8 cups / 2L) of clean, cool water, mixed
according to the recommended instructions
on the bleach container. To sanitize, follow
the below steps:
1. After performing the auto clean cycle
as per the instructions above, add half
(4 cups / 1L) of the recommended
sanitizing solution to the jug. Secure
the lid and inner lid and press AUTO
CLEAN to run a sanitizing clean cycle.
2. Allow to stand for 1 minute,
then empty solution.
3. Soak lid, inner lid (also scraper spatula
and frozen dessert wand if used) in the
remaining second half of the sanitizing
solution mixture for 2 minutes.
4. Place the empty jug and lid back on
blender base and run on manual speed
MIX for 10-20secs to remove any
excess moisture from the blade area.
5. Wipe the exterior of the lid, jug and
base with a soft cloth dampened with
the sanitizing solution.
6. Do not rinse after sanitizing. Allow to
air dry before storage. Rinse with clean
water prior to next use.
Motor base
To clean the motor base, wipe with a soft,
damp cloth then dry thoroughly. Wipe any
excess food particles from the power cord.
Cleaning agents
Do not use abrasive scouring pads or
cleaners on either the motor base or the jug,
as they may scratch the surface. Use only
warm soapy water with a soft cloth.
Dishwasher
The blender jug and lid can be washed in
the dishwasher on a standard wash cycle.
Jug can be placed on the bottom shelf,
however the lid and inner lid should be on
the top shelf only.
Stubborn food stains and odours
Strong smelling foods such as garlic, fish,
spices, and some vegetables such as carrots
may leave an odour or stain on the blender
jug and lid. To remove, soak blender jug and
lid for 5 minutes in warm soapy water. Then
wash with a mild detergent and warm water,
rinse well and dry thoroughly. Store jug with
the lid off.
Storage
Store your blender upright with the blender
jug assembled on the motor base, or beside
it. Do not place anything on top. To allow air
to circulate, keep the lid off.
Dry milling
Please note that milling hard ingredients
like spices, nuts, sugar, coffee, grains, etc
will cause scratching and clouding to the
inside surfaces of the jug.
Note:
This is a cosmetic result from milling
these kinds of ingredients, and does not
affect the performance of the jug.