Page 1 f f @ @ s s t t 3 3 2 2 8 8 4 4 1. Introduction this f@st 3284u cable gateway is an embedded media terminal adapter (emta) which is cablelabs docsis 3.0 and packetcable 1.5 compliant. It provides high-speed internet access as well as cost-effective, toll-quality telephone voice and fax/modem ...
Page 2 wall mounting the number of the screw: 2 pcs direction for wall mounting: led panel upward. Dimension for the screw: 5~7.5 mm there are 2 slots on the underside of the modem that can be used for wall mounting. You will need 2 suitable screws which screw diameter would be 5~7.5 mm to wall moun...
Page 3 3. Connecting the f@st3284 gateway to your computer installation procedure for ethernet interface follow the steps below for proper installation: 1. Make sure your computer meets the system requirements. 2. Connect a coaxial cable to the wall plug 3. Connect a coaxial cable to the cable conne...
Page 4 4. Wireless connection step 1 step 3 step 2 step 4 5. F@st3284u personalization step 1 • open an internet session and type the following address: http://192.168.1.1 step 2 step 3 status to know the state of your connection of your f@st3284u basic to perform the basic configuration of your f@s...
Page 5 6. Precautions and warnings z before connecting and disconnecting cables, stop using the f@st3284u, and then disconnect it from the power supply. Ensure that your hands are dry during operation. Z keep the f@st3284u far from sources of heat and fire, such as a heater or a candle. Z do not blo...
Safety and certifications 25xxxxxxx-a 17 july 2014 1 important information about the sagemcom f@st3284u: installation and safe usage instructions: 1. Place the router in a horizontal orientation on a flat surface. 2. Connect the manufacturer supplied ac to dc power adapter. The f@st3284u requires th...
Safety and certifications 25xxxxxxx-a 17 july 2014 2 federal communications commission (fcc) statements this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any in...
Safety and certifications 25xxxxxxx-a 17 july 2014 3 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/tv technician for help. Fcc radiation exposure statement this equipment complies with fcc ra...
Safety and certifications 25xxxxxxx-a 17 july 2014 4 wall mounting (optional) while many users place their f@st3284u product on their desk, it can be optionally wall mounted. The number of the screw: 2 pcs. Direction for wall mounting: led panel upward. Dimension for the screw: 5~7.5 mm. There are 2...
Federal communication commission interference statement this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that...
Radiation exposure statement: this equipment complies with fcc radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: the country code selection is for non-us model only a...