Sailor 6215 VHF DSC Installation Manual
What’s in the box?
Dimensions for the VHF
How to install the VHF on desktop and overhead
How to install the VHF flush mount
INSTALLATION GUIDE
SAILOR 6215/6216 VHF DSC
Drilling plan on desktop and overhead
Cable assembly for waterproof installation
How to prevent water ingress
99-130249
4 x M4 or hole for
self-tapping ø3.9
150mm
53
mm
71mm
196mm
23mm
9mm
Tilting ±20°
1.
2.
3.
4.
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Note!
- Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
- To ensure waterproof sealing:
If the surface isn’t plane and/or rigid remove the gasket and
seal with silicone sealant between the VHF and the surface.
Very important information!
Do not remove the membrane.
If you remove the membrane the radio will not be waterproof.
Membrane
U-Mounting
Bracket
Transceiver
Gasket
Flush Mount
Bracket (2 pcs.)
Sun Screen
Fuse
6.3x3.2mm (10AT)
Hand Microphone
Wheel Knob
(2 pcs.)
Screw M4x45
TORX 20
(5 pcs.)
Square Nut
M4x7x2.2
(5 pcs.)
Screw M4x12
TORX 20
(5 pcs.)
Screw ø3.9x19
TORX 20
(5 pcs.)
Cap for LTW BD/BU
Connector
(2 pcs.)
Connection Cable,
1 m
Cradle
User & Installation Manual
Screw M4x12
TORX 20 (3 pcs.)
Screw ø3.9x19
TORX 20 (3 pcs.)
Power Cable
Connector for Hand Microphone or Handset - If not used, put the cap
from the ACC connector on the front connector to prevent water ingress.
A
A
B
B
99-130248
Gasket
Flush Mount Bracket (2 pcs.)
Screw M4x45 TORX 20 (4 pcs.)
Connect to LOUD HAILER
(RED isolation on inner connector)
Connect to EXT. SPEAKER
(WHITE isolation on inner connector)
Connect to POWER +
(RED wire)
Connect to POWER -
(BLUE wire)
Square Nut M4x7x2.2 (4 pcs.)
Max wall thickness 26mm