Saitek Cyborg 3D User Manual - page 4
Saitek Smart Technology Software
Saitek Smart Technology software is the software that Saitek supplies for our high-end game controllers. The Smart
Technology software comprises the product drivers for these Saitek controllers and the
optional
programming software.
By keeping the two separate, the Smart Technology software offers two types of installation to suit the individual
gamer’s needs, which means even more gamers can enjoy these quality Saitek products.
The
Quick Install
loads the product drivers only (all that is needed to use the controller) and is suitable for the new or
Typical User
. This install is fast and simple and will have the gamer up and running in no time at all.
The
Full Install
loads the product drivers and the Saitek Smart Technology programming software and is suitable for the
Advanced User
. The programming software delivers a powerful set of features for the ultimate configuration in the
game. Although it is recommended for the seasoned gamer, it can be installed at any time. This gives the typical user a
chance to get to know the controller before taking gaming to the next level.
INSTALLATION FOR USERS OF WINDOWS® XP
Quick Install (Drivers Only)
This installation will
ONLY
install the drivers for your Saitek controller. The Full Install (below), will install the drivers
and the Saitek Smart Technology programming software for your Saitek controller.
Note
: Please do not connect the USB connector until asked to by the installation procedure.
1 With your computer switched on, close down any programs that are currently running and insert the Saitek
Smart Technology CD into your CD-ROM drive.
2 When the
Welcome
screen appears, click
Next
to continue. (If the CD does not run automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Install.exe
and click
OK
- where
D:\
is letter of your CD-
ROM drive).
3 After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and click
Next
to continue.
4 At the
Device Driver Installation
screen, click on
Next
and follow the on-screen instructions.
5 When prompted, plug your USB connector into your computer, then click on
Configure
and then
Continue
Anyway
. Follow the on-screen instructions until you reach the
Controller Properties
screen.