Saitek Cyborg 3D User Manual - page 6
INSTALLATION FOR USERS OF WINDOWS® 2000
Quick Install (Drivers Only)
This installation will
ONLY
install the drivers for your Saitek controller. The Full Install (below), will install the drivers
and the Saitek Smart Technology programming software for your Saitek
controller.
Note
: Please do not connect the USB connector until asked to by the installation procedure.
1 With your computer switched on, close down any programs that are currently running and insert the Saitek
Smart Technology CD into your CD-ROM drive.
2 When the
Welcome
screen appears, click
Next
to continue. (If the CD does not run automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Install.exe
and click OK - where
D:\
is letter of your CD-
ROM drive).
3 After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and click Next to continue.
4 At
the Device Driver Installation
screen, click on
Next
and follow the on-screen instructions.
5 When prompted, plug your USB connector into your computer, then click on
Configure
.
6 When the
Controller Properties
screen appears, click
Next
to view the Test screen.
7 Now try out all your controller’s buttons and controls to show that it is working properly. When you have finished,
click
OK
.
8 At the
Programming Software
screen, select
Typical User
and click
Next
.
9 At the
Registration
screen, select
Register my Saitek controller online
, click next and follow the on-screen instruc-
tions or select
Register Later
and click
Next
.
10 Click on
Finish
to complete the installation. Your Saitek controller is now ready for use with your favorite games.
Full Install (Drivers and Programming Software)
This installation will install the drivers and the Saitek Smart Technology programming software for the Saitek con-
troller.
1 Follow points 1 – 7 of the install procedure in Quick Install (Drivers Only), then at the
Programming Software
screen, select
Advanced User
and click
Next
.