Saivod STE84C User Manual - The Programme Has Started

21 / 80  EN

Dryer / User Manual

Selecting a Programme and Operating Your Machine

 “Ventilation”:

- Illuminates when the programme ends.

C

Anti-creasing icon will light up at the end of the 

programme if anti-creasing function is active.

5.14 Changing the programme after 

the programme has started

You can use this feature to dry your laundry in a 

different program after your machine has started to run. 

For example;

Press and hold the “Start/Pause/Cancel” button for 

about 3 seconds to “Cancel” the programme in order 

to select “Extra Dry” programme instead of “Iron Dry” 

programme. Select the “Extra Dry” program by rotating 

the program knob. Press “Start/Pause/Cancel” button to 

start the program.

C

If you select a new programme by turning the 

programme selection knob while your machine 

is running, then the current program is cancelled 

and new programme information is displayed.

5.15 Adding/removing laundry in 

standby mode

In order to add or take out laundry after the start-up of 

the programme; 

1. Press the “Start/Pause/Cancel” button to switch the 

machine to “Pause” mode. Drying process will stop.

2. Open the door at Pause position and close it again 

after adding or taking out laundry.

3. Press “Start/Pause/Cancel” button to start the 

program.

C

Any laundry added after the drying process was 

started may cause the already dried clothes in 

the machine intermingle with wet clothes and the 

result will be wet laundry after the drying process 

is over.

C

Laundry may be added or taken out as much 

as desired during a drying process, but as this 

process will interrupt drying continuously, it will 

extend the program duration and increase energy 

consumption. 

Therefore, it is recommended to add laundry 

before the drying programme has started.

C

If you select a new programme by turning the 

programme selection knob while your machine is 

in standby, then the current program is cancelled 

and new programme information is displayed

5.16 Child-proof lock

There is a child-proof lock to prevent any programme 

interruption due to the pressing of button while the 

programme is running. The loading door and all button 

except the “On/Off” button on the panel are deactivated 

when the child-proof lock is active.

In order to activate the child-proof lock, press on 

the “audio warning” and “anti-creasing” buttons 

simultaneously for 3 seconds. 

To start a new programme after the programme is over 

or to interrupt the programme, the child-proof lock 

should be deactivated. Press the same buttons for 3 

sec. again to deactivate the child-proof lock.

Lock symbol will appear on the screen when the child-

proof lock is activated.