Sakar 94379 Owner's Manual - page 2
Self-Timer
Timer with 10 sec delay
Video mode
24 bits(R/G/B)
Video frame rate
12 fps (Hr), 25 fps (Lr)
Expose / White balance
Auto/Auto
Power source
2 x 1.5V AAA alkaline / USB 5V
Auto power off
30 sec.
PC interface
USB 1.1
Operation System
Windows98/2000/Me/XP
Weight
Approx. 80g(without 2 AAA batteries)
Dimension
68(H) x 98(L) x 34(T) mm
Start to use camera stand along:
1.Battery installation:
On the bottom of the camera, slide the battery door in the direction
indicated by the arrow to open it. Insert two AAA size alkaline batteries as +/- marking
indicated on the inner side of the battery door. Close the battery cover.
Note:
LCD will flash when the batteries in the unit are running out, you can’t take photos at this time
and please replace new batteries. When the voltage drop down to 2.2 volts, "Lo” appears
on the LCD and blinks then the unit will be power off automatically.
2.Turn on the power:
Press mode button about two seconds to turn on the power, and then operate after beep.
(Automatic power off after idling 30 seconds).
3
.
Photo taking:
Press shutter button, camera will beep once after the image saved, it means you
take a picture successfully and number on the LCD display increase by 1. When pressing the
shutter button, the buzzer will ring out twice. It indicated that the digital camera is at full capacity.
4.Mode selection:
A. Hr: High resolution Lr: Low resolution
4.1.
Press the mode button to select
Hr
or
Lr
shown on the LCD display.
4.2.
Hr
means VGA mode of 300K resolutions and Lr means CIF mode of 100K resolutions.
4.3. If the LCD shows
Hr
means the present resolution mode is setting for
Lr.
Press the
shutter button within 5 seconds to change the resolution to
Hr
and the rest of photos
you may take will change upon this resolution. If the LCD shows
Lr
means the present
resolution mode is setting for
Hr.
Press the shutter button within 5 seconds to change