Sakura COOLING ONLY Installation, Operation & Maintenance Manual - page 19
WIRE CONNECTION
- All electrical work must be carried out by qualified electrician and accordance with local supply
requirement and associated regulation.
- The unit is to be wired directly from an electrical distribution board either by a circuit breaker (preferred)
or HRC fuse.
- Fix the power supply wiring to control module. Connect control wiring to control terminal block through
the control box’s hole.
Note: Earth wiring must be connected.
Arrangements of control component and terminal block for controller are shown below.
No. Descriptions
1
Terminal Block for Main Supply
2
Terminal Block for Control
3 Terminal
for
Earth
4
Magnetic Contactor for Compressor
5
Magnetic Contactor for Evap. Fan Motor
6 Fuse
7
Reverse Phase Protection
8 Controller
Method for connecting electric wire
Before connecting the wire, consult the electric power company of jurisdiction.
The entire wiring diagram of unit.
Wiring connection to unit
Remove the panel and connect the units power supply wires to terminal block, as shown below.
Notes: For all electrical wiring must be comply with local electrical authority regulations.
8
1
2
3
6
5
4
7
18
SAKURA - Total Air Conditioning Solution