Sakura COOLING ONLY Installation, Operation & Maintenance Manual - Warning

1

FEATURES 

Electro Galvanized Steel Panels 

Corrosion Resistant Cabinet

  -  The weather proof characteristics of the panels have been significantly 

reinforced by the adoption of electro galvanized steel panel which have been coated with polyester powder 

coated paint to resist corrosion. 

Protection System 

Compressor Protection

  -  The compressor is protected with high pressure switch, an over current relay, 

a crankcase heater, an internal thermostat, a reverse phase protection relay and a cycling protection timer 

delay for compressor. 

Fan motor

  -  The evaporator fan motor and outdoor fan motor are protected with thermal over current 

relay.

Condenser and Evaporator Coil

  -  The coil have seamless Inner groove copper tubing mechanically 

bonded to high efficiency. Each coil is factory tested at 400 psig. And easily accessible for service.

SAFETY PRECAUTIONS 

Before installing the air conditioner unit, please read the following safety precautions carefully. 

Warning 

•  Installation and maintenance should be preformed by qualified persons who are familiar 

with local code and regulation, and experienced with this type of appliance. 

•  All field wiring must be installed in accordance with the national wiring regulation. 

•  Ensure that the rated voltage of the unit corresponds to that of the name plate before 

commencing wiring work according to the wiring diagram. 

•  The unit must be GROUNDED to prevent possible hazard due to insulation failure. 

•  All electrical wiring must not touch the refrigerant piping, compressor or any moving parts 

of the fan motors. 

•  Confirm that the unit has been switched OFF before installing or servicing the unit. 

•  Do not touch the compressor or refrigerant piping without wearing gloves. 

Caution 

Please take note of the following important points when installing. 

- 

Do not install the unit where leakage of flammable gas may occur. 

If gas leaks and accumulates at the surrounding of the unit, it may cause fire ignition. 

- 

Ensure that the drainage piping is connected properly. 

If the drainage piping is not connected properly, it may cause water leakage. 

- 

Do not overcharge the unit. 

This unit is factory full charged. Overcharge will cause over-current or damage to the 

compressor. 

- 

Ensure that the unit panel is closed after service or installation. 

Unsecured panels will cause the unit to operate noisily. 

SAKURA - Total Air Conditioning Solution