Salton IM2096 Instruction Booklet - Before First Use
BEFORE FIRST USE
1. Remove all packaging and tape. Make sure that you have the Ice Basket,
Ice Scoop and Water Tube Screen before discarding packaging.
2. Place the Ice Maker on a solid level surface, away from direct sunlight and
other sources of heat, such as a stove, furnace and or radiators.
3. Position the Ice Maker so that it is 4” (10 cm) away from the wall on all
sides and that the plug is accessible.
4. After positioning the Ice Maker, wait 1 hour before starting the ice maker
to allow the refrigerant fluid to settle.
5. Wash the interior, Ice Basket and Ice Scoop. See the Care and Cleaning
section. Place the Water Tube Screen over the Water Tube opening if it has
been dislodged.
6. Make 2 batches of ice and discard. NOTE: It is possible that the 1st and
2nd batch will have a slight odour because of the manufacturing process.
Subsequent batches will not be affected.
IMPORTANT NOTE:
In the event that the power to the Ice Maker is inadvertently disconnected
during the ice making cycle or there are alarm lights blinking on the control
panel, press the Power Button once so that it is blinking, then unplug the unit.
Wait a few minutes until the Ice Maker warms up and the ice has fallen from
the Evaporator Fingers. Empty the Water Tray by following the directions in the
Care and Cleaning Section. Wait 3 minutes then plug the Ice Maker into the
wall outlet. Follow the directions in the How to Use section.
4
Booklet_IM2096_EN.qxd:Salton Booklet 8/16/11 11:18 AM Page 4