Salus iT500 Instruction Manual - page 27
iT500 User Reference Manual
27
Selecting the System Configuration
The first step is to select the system configuration, as follows:
1. When the iT500TX enters Installation Setup mode, the display changes to show the Zone 1
, Zone 2
and Hot Water
icons flashing:
2. Press the
button. The display then changes to show the flashing Zone 1 icon only:
3. Press the
and buttons to cycle through the three different system configurations.
Once the required system configuration has been selected, other installation options may be selected, as
described next.
This is the indicator for the single central heating zone system
configuration. If this is the system configuration you want, press the
button again.
This is the indicator for the two central heating zones system
configuration. Press the
button to select this system
configuration.
This is the indicator for the single central heating zone plus hot
water system configuration. Press the Confirm button
to select
this system configuration.