- DL manuals
- Salus
- Thermostat
- rt505tx
- Instruction Manual
Salus rt505tx Instruction Manual
Summary of rt505tx
Page 1
The rt505tx can be used with any of these receivers rxrt505 rxrt505 rxwbc605 rxvbc605 rxst625 rxbc605 868 mhz rt505tx programmable room thermostat salus rt505tx manual blue_89 12/03/2014 10:42 page 1.
Page 2
Rt505tx instruction manual 2 rt505tx rt505tx rt505tx rt505tx rt505tx rt505tx rt505tx instruction manual 2 salus rt505tx manual blue_89 12/03/2014 10:42 page 2.
Page 3: Product Compliance
Product compliance this product complies with the essential requirements of the following ec directives: • electro-magnetic compatibility directive 2004/108/ec • low voltage directive 2006/95/eec • ec marking directive 93/68/eec safety information these instructions are applicable to the salus contr...
Page 4: Introduction
Introduction a programmable thermostat is a transmitter that combines the functions of both a room thermostat and heating controller into a single unit. The programmable thermostat is used to switch the heating system in your home on and off as needed. It works by controlling the temperature accordi...
Page 5: After Installation
The ideal position to locate the rt505tx thermostat is about 1.5m above floor level. It should be mounted in a location where the thermostat is accessible, reasonably lit and free from extremes of temperature and draughts. Do not mount the thermostat on an outside wall, above a radiator or in a loca...
Page 6: User Interface and Controls
If the reset button is pressed, the rt505tx will behave in the same way as described above, except that any previously saved user settings stored in the internal memory will be deleted and overwritten with the default settings, and all programmable thermostat control settings will be returned to def...
Page 7: Operation
Operation the rt505tx is configured and adjusted by the use of a minimal number of user controls, and an intuitive user interface. The backlit liquid crystal display (lcd) gives a highly visible, easily readable indication of the programmable thermostat status. Setting the time press and hold set an...
Page 8: Programming The Rt505Tx
Programming the rt505tx the rt505tx offers great versatility with its programming options, allowing the user to programme the unit to operate on a 5/2 or 7 day control cycle. The programmable thermostat has a default set of programmes that have been designed to meet the needs of most users. If these...
Page 9: 7 Day Mode
Press the up or down key to adjust the hour setting to the desired value, and confirm your selection by pressing the select key. Pressing the select key allows you to step through each of the items to be reviewed or adjusted within the programmes in the following sequence: programme function sequenc...
Page 10: Frost Protection
Press the up or down key to adjust the hour setting to the desired value, and confirm your selection by pressing the select key. Pressing the select key allows you to step through each of the items to be reviewed or adjusted within the programmes in the following sequence: programme function sequenc...
Page 11: Temporary Override
Reviewing set point temperature you can view the set point temperature at any time by pressing either the up or down key. When any programme is running, the lcd display will show the programme set point temperature with the set indicator displayed: when operating in frost protection mode, the lcd di...
Page 12
Once in temporary override mode, the clock and day are displayed, along with the set indicator; all other indicators are cleared from the display. The set point temperature will flash to indicate that it can be changed: pressing the up or down key will increase or decrease the set point temperature ...
Page 13: Your Receiver
Setting up rf communication with your receiver rxrt505 (only) after you have switched the above receiver on, the thermostat will automatically pair. When the red led stops flashing, the unit has successfully paired. If you have difficulty in pairing the thermostat, we recommend changing the address ...
Page 14: Rxbc605
Rt505tx instruction manual 14 rxbc605 location of sync buttons on receivers rxst625 rxvbc605 rxwbc605 for full instructions on pairing the receiver refer to the rxbc605 manual. Sync button for full instructions on pairing the receiver refer to page 9 of the rxst625 manual. For full instructions on p...
Page 15: Testing The Rf Transmission
Testing the rf transmission 1. Press the up button on the thermostat until the set point temperature is higher than room temperature by a few degrees. 2. Wait for a few seconds. The boiler on (heat call) indicator should appear on the bottom left of the lcd on the thermostat. 3. Check the led on the...
Page 16: Sleep Mode
Sleep mode by pressing both the up and down keys together, the rt505tx will enter sleep mode. In this mode, all the rt505tx functions will be paused to save battery power, with the exception of the clock which will continue to run in the background. While in sleep mode: • the lcd display will be bla...
Page 17: Product Specification
Product specification model: rt505tx type: electronic programmable thermostat, designed for rf heating applications. Frequency 868 mhz programming programming modes: user selectable for 5/2 or 7 day option number of programmes: five (5) user programmes plus factory default programme. Override facili...
Page 18: Clock
Clock accuracy: ± 1 minute per month display: 12 hour frost protection setting: 5 ºc environment operating temperature: 0 ºc to + 40 ºc storage temperature: - 20 ºc to + 60 ºc rt505tx instruction manual 18 salus rt505tx manual blue_89 12/03/2014 10:42 page 18.
Page 19
Salus controls warrants that this product will be free from any defect in materials or workmanship, and shall perform in accordance with its specification, for a period of two years from the date of purchase. Salus controls sole liability for breach of this warranty will be (at its option) to repair...
Page 20: Sales
Email: sales@salus-tech.Com tel: 01226 323961 email: tech@salus-tech.Com tel: 01226 323961 sales : technical : salus controls plc, salus house, dodworth business park south, whinby road, dodworth, barnsley s75 3sp salus-controls. Salus rt505tx manual blue_89 12/03/2014 10:42 page 20