Salus rt505tx Instruction Manual - After Installation
The ideal position to locate the RT505TX thermostat is about 1.5m
above floor level. It should be mounted in a location where the
thermostat is accessible, reasonably lit and free from extremes of
temperature and draughts. Do not mount the thermostat on an
outside wall, above a radiator or in a location where it may be
subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF)
signal, always ensure that the programmable thermostat is
mounted away from any possible sources of interference (such as
radios, TV sets, computers, etc.), and is not mounted on or in close
proximity to large metal objects. Installing the RT505TX in
enclosed areas such as cellars and basements is not recommended.
AFTER INSTALLATION
The following table shows the settings of the RT505TX programmable
thermostat after Power on, or after RESET is pressed:
Function
Status After Reset or Power On
Operation Mode
Normal mode
Room Temperature
22.0 °C, updated within 5 seconds
°C indicator
On
Clock
12:00
AM/PM indicator
AM
Day of Week indicator
M
Program
Default factory setting
Set Point Temperature
Default factory setting
Program Number indicator
1
SET indicator
Off
PROG indicator
Off
Frost Protection indicator
Off
Heat indicator
Off
Low-Battery Warning indicator
Off, updated within 5 seconds
Output Relay
Off
After Power on, the thermostat will operate in
Normal
mode (Normal mode
is when the thermostat is displaying the room temperature):
•
The set point temperature is reset to the default setting
•
The room temperature display is updated within 5 seconds
•
The control process starts
•
The programme number is updated to indicate the running program
RT505TX INSTRUCTION MANUAL
5
Salus RT505TX Manual Blue_89 12/03/2014 10:42 Page 5