Salute HM108 Owner's Manual - What You Can
Congratulations on your excellent choice. Your
Saluté Superior Super Blender will make a huge
difference to your lifestyle and your health. The
Saluté allows you to convert fruit and/or
vegetables into deliciously healthy treats in
seconds and also supports the processing of dry
materials. The Saluté carries a 2 year warranty on
the motor and 1 year on other parts.
!
The warranty is valid for Household use only and
covers manufacturing defects. Parts broken
through wear and tear are not warranty claims.
!
Email :
info@healthessentials.co.za
What you can
make with your
New Saluté
Superior Super
Blender
• Green Smoothies
• Fruit Smoothies
• Savoury Smoothies
• Hot Raw Soup
• Cooked Soup
• Creamy Nut Butters
• Baby Foods
• Whipped Cream
• Sauces and Dressings
• Crush Ice
• Batter
• Grind Grains
• Raw Desserts
• Make Coleslaw
• Green Juice
• Melt Cheese or Chocolate
• Dips and Pâté
• Pesto
• Hummus
• Guacamole
• Grind Coffee Beans (See page 6)
• Breadcrumbs
• Frozen Treats
• Churn Herb Butter from Fresh Cream
• Sorbets
• Purées
• Frappé Fabulous Coffee
• Grind Herbs & Spices
1.
After each use, rinse the jug thoroughly with
warm water.
2.
Place one to two drops of dishwashing liquid into
your jug and fill it halfway with warm water.
3.
Secure the lid with the lid plug in the locked
position.
4.
Start the machine on Min speed, slowly increase
to Max with the Speed control knob.
5.
Run for about one minute.
6.
Empty the jug out and rinse thoroughly.
7.
Turn the jug upside down and let it air dry.
8.
Deep cleaning can be done with Milton or
vinegar. Important note: The blade must not be
soaked in these substances.
!
Note: The jug of the Saluté is not dishwasher safe.
Cleaning Your Saluté
My machine will not switch on - Have you got the jug on the base? Without the jug the safety switch is on,
The Saluté cut out while I was processing
Possible Cause 1:
The machine has probably overheated and cut out. Your Saluté is engineered with an automatic thermal
overload protection mechanism to prevent the motor from burning out.
Reasons for overheating:
1. Processing heavy materials for too long.
2. Processing heavy materials on too slow a speed.
3. Processing too much heavy material that does not contain liquid.
Solution:
1. Press the reset button at the rear of the machine.
2. Leave the machine off for 10 – 30 minutes to cool down. (The cool down period is dependent on the
ambient temperature). If the machine is still not working, check Possible Cause 2.
Possible Cause 2:
Please check the obvious options such as faulty plug connections. If the machine is not working, contact
customer care.
I damaged the tamper/blade
1. I put the tamper into the jug with the lid off and it hit the blade
2. I used another utensil instead of the tamper and it hit the blade. The blade stopped turning / the tamper is
damaged)
Solution:
The drive socket (the mushroom-looking part that sits in the middle of the black rubber mat on the base) has
been damaged. This is a safety mechanism to stop the blades from causing further damage.
Order a new drive socket from www.healthmakers.co.za/store This is a DIY repair with instructions. If the blade
is damaged then a complete blade assembly needs to be replaced.
Customer Care: Complete and submit the Service Form at:
www.healthmakers.co.za/store/repairs-and-returns
Email:
service@conglomus.co.za
Troubleshooting
SAFETY WARNING!
To ensure safety unplug the power cord before cleaning the base. Never immerse the motor
base in water and never clean the blade assembly with your bare hands