Sam SAM-EK1 User Manual - page 4
5
6
Installation
- Activate the PIR detector by removing the battery activation
strip. The PIR detector will immediatly self-test. After one
minute of self-testing, install the PIR detector.
- Avoid mounting the detector close to places where the
temperature changes fast or the air stream flows frequently
(ie. AC units and heating vents.)
- Fix the bracket to the wall with screws.
- Attach the detector to the bracket. Adjust installation height or
bracket to change the detection distance and angle. Installation
height is 6.5 Ft (2m) from the ground.
Note: The detector is more sensitive to cross-movement than to
direct movement. The performance of the detector is optimal
when the detection direction is across the walking direction
of intruders.
- Press the test button. Walk in the detection area (from left to
right or from right to left) and watch the LED indicator to make
sure the detector is working. The LED indicator should flash
once when body movement is detected.
- Adjust the detector’s viewing angle to achieve the best
detection.
TEST BUTTON
6.5Ft (2m)
TOP VIEW
GROUND
SIDE VIEW