Samick SG310 Owner's Manual - Connections

In the SG310 and SD

In the SSP30 the sockets are located at the back  of the instrument. 

CONNECTIONS 

MIDI IN/THRU/OUT 

The Midi THRU connector retransmits any data from the Midi IN directly to other Midi devices. 

The Midi OUT connector transmits Midi data generated by the instrument to other Midi 

instruments. 

The Midi IN connector receives the Midi data from an external Midi device.  

USB TO COMPUTER  

It is possible to connect the instrument to a computer using the USB port located in the back panel 

of the instrument and control the Midi parameters.  

PEDALS SOCKETS 

This is the connection for the pedal sets that can be used with the instrument.

If using the supplied Sustain Pedal connect it to Pedal Connection 1. 

If  the optional 3 Pedals pedal board is used connect the mono jack to pedal connection 1 and the 

stereo jack to pedal connection 2. 

LINE IN SOCKETS 

There are  two inputs (Left and Right) and they are used to send the audio signal of an external 

instrument to the internal amplifier.

LINE OUT SOCKETS 

There are  two outputs (Left and Right) and they are used to send the audio signal out an external 

amplifier, mixer console or recording equipment. To connect the instrument in Stereo to an external 

amplification system connect both Left and Right outputs.  

HEADPHONES  

Two sets of Headphones can be plugged in for private practice and allow you to play without 

disturbing anyone else or being disturbed by outside noise.

P31 are located in the front of the instrument, below the hammer action 

keyboard. 

POWER ON/OFF 

This switch turns the power to the instrument on or off.

DC IN SOCKET 

This is the connection to power. Connect the adapter to this socket to power the instrument. 

24