Samlex Europe WSC-1215 Manual - 5 Accessories
17
5.3.2 Installation
• Connect this remote controller to the “REMOTE” socket of the charger (See Figure 17
Making Connections (RC-601D), Page. 10).
• Ensure approximately 80mm width, 72mm height and 28mm depth for the take-up of the
remote controller.
• Connect the remote controller to the charger. The connection cable is equipped with two
equivalent modular plugs.
• Place the remote controller into the opening created. Secure the remote controller with
screws on the upper and bottom margin of the faceplate – use the available drills.
Note
The length of RC-601D cable is 10M
For mounting battery charger on wall or flat places (please refer from Figure 4 WSC-1215 / WSC-2408
Charger Top View, Page. 3 and Figure 6 WSC-1230 / WSC-2415 Charger Top View, Page. 4) regarding the
size of housing and the location of mounting holes for your installation.
Refer to Figure 8 Making Connections, Page. 5.
• Place the charger in a dry, cool, clean, and ventilated space.
• Set the power switch to “0” (off) and pull out the main plug before connection or discon-
necting the direct current connection.
• Connect the “-“(minus) battery pole with a connecting cable with the”-“(minus) terminal at
the charger (see Figure 8 Making Connections, Page. 5).
• Connect the “+”(plus) battery pole with the connecting cable with the “+”(plus) terminal at
the charger (see Figure 8 Making Connections, Page. 5).
• Lay the cables from the batteries to the charger.
• Fold the cable ends with the multicore cable ends.
• If the charger with the option of charging output for starter battery, please connect the
terminal of "SB".
• Supply the cable with a fork connection for an idea connection with the terminal (see
Figure 10 Fork, Page. 6).
Ensure correct polarity of the battery and the battery charger, otherwise the internal flat-pin terminal will
trigger with the wrong polarity.
5 Accessories
6
Mounting of Battery Charger
7
Making Connections
ENG