Wsc-1215 (sb) wsc-1230 (sb) wsc-2408 wsc-2415 model no. Battery charger manual please read this manual carefully before installing and starting up this device. Smart battery charger.
2 figure 1 wsc-1215sb / wsc-1230sb charger front view figure 2 wsc-1215 / 1230 / 2408 / 2415 charger front view.
3 figure 4 wsc-1215 / wsc-2408 charger top view (mm) figure 3 charger rear view.
4 figure 6 wsc-1230 / wsc-2415 charger top view (mm) figure 5 wsc-1215 / wsc-2408 charger side view (mm).
5 figure 8 making connections figure 7 wsc-1230 / wsc-2415 charger side view (mm).
6 figure 9 cable setup figure 10 fork.
7 figure 12 temperature sensor tf-100 figure 11 switch.
8 figure 14 remote controller rc-600 dimension (mm) figure 13 remote controller rc-600
9 figure 16 remote controller rc-601d dimension (mm) figure 15 remote controller rc-601d.
10 figure 18 temperature sensor setup figure 17 making connections (rc-601d).
11 contents eng 1 general safety and installation instructions 12 1.1 operate the device safely 12 1.2 safety instructions when installing the device 12 1.3 electrical cables 12 1.4 installation on boats 12 2 warning 13 3 applications and descriptions 13 4 introduction of the unit variants 14 5 acce...
12 1.1 operate the device safely warning! Failure to observe this instruction can cause material damage, device malfunction, or danger of bodily injuries. Fundamental safety measures should be observed when using electrical equipment to avoid the danger of: – electric shock – fire hazard – injury 1....
13 warning! Please read carefully about the following precautions. Damages caused by failure to follow the instructions below will not be covered by warranty. • use the charger only as intended. • do not operate the charger if the housing or the cables are damaged. • the charger may not be used to c...
14 the 4-stage battery charger can deliver different unit variants. It can charge batteries up to the specified battery capacity as indicated in the specification section. Regarding the identifi- cation of the specification of your unit, please see the model number on the type plate. Front view mode...
15 5.1 temperature sensor tf-100 the temperature sensor (figure 12 temperature sensor tf-100, page. 7) measures the temperature of the battery or the environment around the battery and transfers the data to the charger. With deviating temperatures, the charging voltage increases and decreases accord...
16 5.2.2 installation • ensure approximately 49mm width, 49mm height and 23mm depth for the take-up of the remote controller (see figure 14 remote controller rc-600, page. 8). • connect the remote control to the charger. The connection cable is equipped with two equivalent modular plugs. • place the...
17 5.3.2 installation • connect this remote controller to the “remote” socket of the charger (see figure 17 making connections (rc-601d), page. 10). • ensure approximately 80mm width, 72mm height and 28mm depth for the take-up of the remote controller. • connect the remote controller to the charger....
18 warning! Batteries with cell connection may not be charged. Explosive gases could result from battery overheating. Note only use cables with the designated wire cross sections to connect the charger to the battery. Model no. Supply battery wsc-1230, wsc-1230sb awg # 10 ~ awg # 8 wsc-1215, wsc-121...
19 8 settings eng 8.2 half power mode setting when the switch s2 “half power” is pushed, the output power will reduce to half of the chargers' amp rating and the “status” led will flash. The switch s2 is a kind of no memory switch. That means "on/off" status cannot be identified from the switch. To ...
20 push switch on front panel original working mode half power equalization others power supply s2 "half power" pushed exit "half power" ("status" led lights) void enter "half power" ("status" led flashing) void s3 "e.Q." pushed void void equalization ("e.Q." led lights red) void 8 making connection...
21 9 using the charger eng 9.1.1 i phase (bulk) the "status" led constantly lights red. In the first stage of the charging process, the depleted battery is charged with a constant current until the battery voltage reaches i phase setting voltage (13.5v/13.8 v or 27.0v/27.6 v). When the battery reach...
22 9 using the charger eng 9.1.5 equalization the function of equalization could be activated as long as the battery charger is not in the half power mode or power supply mode. The function of equalization will be activated only when the battery is charged and stays in uo phase with the battery char...
23 rc-600 buttons charger working mode half power equalization others power supply "half power" pressed exit "half power" ("status" led lights) void enter "half power" ("status" led flashing) void s3 "e.Q." pushed void void equalization ("e.Q." led lights red) void "on/off" pressed stand by ("status...
24 9 using the charger eng figure 20 temperature compensation for 12v model figure 21 temperature compensation for 24v model.
25 9 using the charger eng note • the temperature sensor is only working in i, uo and u phases. • the output voltage is adjusted according to the function -25mv/°c for wsc-1215, wsc-1215sb, wsc-1230 and wsc-1230sb, and -50mv/°c for wsc-2408 and wsc-2415. However, the maximum output voltage is 15v/30...
26 9 using the charger eng "e.Q." led "status" led status red, constantly lit i phase orange, constantly lit uo phase green, constantly lit u phase red, constantly lit red, constantly lit i phase, equalization is acti- vated red, constantly lit orange, constantly lit uo phase, equalization is activa...
27 10 trouble shootings eng 10.2.1 12 v battery if the multi-meter displays a voltage of 10 v or less, this indicates that the battery is defective and can not be charged any longer. 10.2.2 24 v battery if the multi-meter indicates a voltage of 20 v or below, allow the battery be checked by a specia...
28 11 specifications model number: wsc-1215 wsc-1215-sb wsc-2408 input voltage range 100-240v ac input frequency 50-60hz power factor correction >0.97 efficiency at 230v ac >90% >91% efficiency at 115v ac >87% >88% input current at 230v ac 1a 1.1a 1.1a input current at 115v ac 2.1a 2.3a 2.2a charge ...
29 11 specifications model number: wsc-1230 wsc-1230sb wsc-2415 input voltage range 100-240v ac input frequency 50-60hz power factor correction >0.97 efficiency at 230v ac >91% >92% efficiency at 115v ac >89% >90% input current at 230v ac 2.0a 2.2a 2.0a input current at 115v ac 4.2a 4.4a 4.0a charge...
30 declaration of conformity for the following equipment : product name: smart battery charger model no.: wsc-1215,wsc-1215sb,wsc-1230,wsc-1230sb,wsc-2408, wsc-2415 trade name: applicant: samlex europe b. V. Address: aris van broekweg 15, 1507 ba zaandam the netherlands is herewith confirmed to comp...
Www.Samlex.Com www.Samlex-solar.Com.