Owner's manual s a m l e x a m e r i c a . S a m l e x a m e r i c a . Sec - 1215a sec - 1230a sec - 2415a models automatic battery charger please read this manual before operating your charger..
Contents safety, input voltage selection ............................... 1 intended use, features ................................................ 2 installation & connection ......................................... 3 operation ...................................................................... ...
Samlex america inc. Automatic battery charger about the battery charger : n the samlex charger must only be used for the purposes specified. N when working on the charger, always disconnect it from the main ac power source. N do not operate the charger if the housing or cables are damaged. N the cha...
About the cables: cable routing and installation information n if cables have to be inserted through metal walls or other sharp-edged material, use a cable duct or cable bushing n do not lay cables loose or with sharp bends on electrically conductive materials (metal). N secure the cables properly. ...
Installation warning! Before plugging the unit to the ac outlet, please check that your local supply voltage is 115 vac. If your local supply voltage is 230 vac, change the internal voltage selection to 230 vac ( see under selecting input voltage on page 1 ) samlex chargers are designed for easy...
Operation charging stages stage 1 - bulk charge mode when the battery is low, it will attempt to draw a large charging current. The charger senses the current draw and limits this to the maximum permissible value. (15a for sec-1215a and sec-2415a and 30a for sec-1230a). Bulk charging takes place at ...
Operation 1 if your battery is not fully charged, the charging meter will indicate current drawn. As the battery approaches being fully charged, the charging current will decrease. 2 when the meter reads zero, the battery is fully charged. These chargers are fully automatic and require no maintenanc...
Troubleshooting symptoms when the charger is powered and connected to the battery the red led is off the dc side fuse may have blown due to wrong polarity of battery connection. Ensure positive of the battery is connected to the positive of the charger and the negative of the battery is connected to...
If the ac input voltage is correct, the charger is defective. Call technical support dc side fuse blows as soon as the battery is connected wrong polarity. Ensure positive of the battery is connected to the positive of the charger and the negative of the battery is connected to the negative of the c...
Page 8 specifications input voltage (pre-set) (internal jumper change) input frequency output voltage, boost output voltage, float output amps operating temp. Range weight housing dimensions l x w x h inches cms protections output banks 98-132 volts, 60 hz 207-253 volts, 50 hz 50-60 hz 14.3v( pre-se...
Page 9 1 year limited warranty sec-1215a/sec-1230a/sec-2415a manufactured by samlex america, inc. ( the “ warran- tor “ ) is warranted to be free from defects in workmanship and materials under normal use and service. This warranty is in effect for 1 year from the date of purchase by the user ( the ...
S a m l e x a m e r i c a . S a m l e x a m e r i c a . 110-17 fawcett road coquitlam b.C., canada v3k 6v2 e-mail: samlex@samlexamerica.Com website: www.Samlexamerica.Com sec1215a/1230a/2415a ver.B (050801).
