Samlexsolar SRV-120-KIT Owner's Manual - page 13
13
7
WIRING
7.2. Solar Panel to Charge Controller
1. Determine the position of the solar panel on the RV roof. While positioning panels, avoid shading of the
solar panel by neighbouring obstacles such as vents, air-conditioners, TV antennas etc. As far as possible,
position the panels to minimize wiring distance between the solar panel and the charge controller. Place
the panel at least 8-10 inches away from the RV roof edges and leave sufficient space to walk around the
panel and access the mounting hardware.
2. Make sure the thickness of the roof at the installation location is at least ½” thick and the material
is strong enough to provide mechanical support to the solar panel and mounting hardware against
possible wind loading. Place the panel length-wise to reduce the effects of wind loading on the RV.
1. Negative wire with MC4 Female connector (marked “+”)
2. Positive wire with MC4 Male connector (marked “-”)
1
2
Fig. 7.2. PV extension wires
3. Two pre-assembled, 20 ft, AWG #12, Positive (+) & Negative (-) PV extension wires have been provided
(see Fig. 7.2). The wires have MC4 mating connectors on one end for connecting to the solar panel &
bare ends on the other side for connecting to the Charge Controller. The wires are marked (+) & and (-)
for identification of the polarity.
4. Please read sections 6.3 & 6.4 on connecting the extension wires to the panels.
solar
panel
refrigerator
vent cover
vent
screen
method B
method A
Fig. 7.3. PV extension entry through RV Vent