Samlexsolar SRV-120-KIT Owner's Manual - page 16
16
8
SOLAR PANEL INSTALLATION
Typical Installation of a Well-Nut
flange
1/2” diameter
1/4” captive brass nut
Fig. 8.4. Well-Nut is inserted into
a pre-drilled hole with its flange
against the outer surface. There
is no need for access to the
inner side.
flange
1/2” diameter
1/4” captive brass nut
Fig. 8.5. The 5-hole mounting
bracket is placed against the flange
of the Well-Nut and is secured
by the bolt engaging the captive
brass nut.
flange
1/2” diameter
1/4” captive brass nut
Fig. 8.6 . As the bolt is tightened, the
neoprene body of the Well-Nut is
compressed and expanded, forcing
it tightly into the bolt's threads and
against the inner surface of the thin RV
roof material.
flange
1/2” diameter
1/4” captive brass nut
Fig. 8.7. Installed in a blind
hole in a solid material, the
body of the Well-Nut expands
tightly against the walls of
the hole, effecting a secure,
dependable fastening.
7. To install the Well-Nuts, drill holes 1¼” deep at the marked positions using a ½” size drill bit. Make sure
that drilling does not interfere with pre-existing wiring installations.
8. Apply silicone or any appropriate sealant recommended by your RV dealer generously to the drilled
holes for water-proofing.
9. Insert the ¼” Well-Nut into the drilled holes so that only the flange section remains above the roof
surface (Fig. 8.4).
10. Fasten the mounting brackets to the roof surface by inserting the ¼ x 1¼” serrated flange bolt into the
Well-Nut (Fig. 8.5). Tighten using a 3/8” wrench to a recommended torque of 15 lbs. When the serrated
flange bolt is screwed into the Well-Nut, the material surrounding the well nut bulges slightly securing
the structure to the RV roof (Fig. 8.6 & 8.8).
11. Make sure all bolts and mounting brackets are covered by good amounts of suitable RV sealant
recommended by your local RV dealer.
Rubber bushing material expands
when bolt is tightened to securely
anchor hardware
solar
module
¼”-20 x 1¼” flange bolt
¼” flat washer
Well-Nut
mounting bracket
RV roof material
up to approx. 3/8”
thickness
Fig. 8.8 Attaching 5-hole mounting bracket to RV Roof