Ac power source owner's manual please read this manual before operating your inverter. Version#011701 110-17 fawcett road, coquitlam b.C., canada v3k 6v2 e-mail: samlex@samlexamerica.Com website: www.Samlexamerica.Com d c - ac i n v e r t e r s model: p s e - 1 2 6 0 a.
1 14 warning please take the following precautions. Failure to abide by these requirements will void the warranty. Never parallel the 115v ac output of the inverter with the output from a generator or the electric mains. This will instantly burn the inverter. Although this inverter has a high input ...
Introduction the samlex pse-1260a inverter is a member of the most advanced line of mobile ac power systems available. This model is used in a wide range of applications including, remote homes, rvs, power boats, sail boats, and campers. It will operate most televisions and vcrs, personal computer...
C. Chassis ground a. On/off switch leave the switch in the off position during installation. B. Over load indicator lights when the inverter shuts down due to overloading. Turn inverter off, remove the cause of overload and turn the inverter on to restart. C. Ac outlet standard north american 3 ...
4 11 specifications pse 1260a input voltage range 10 - 15 vdc output power continuous 600 watts surge 1000 watts output voltage 115 vac + 5% - 10% output frequency 60 hz output wave form modified sine wave efficiency 85 - 90% no load current draw low battery alarm 10.7 vdc low battery shut down 10.0...
Problem possible cause solution & symptoms low battery alarm poor dc wiring, poor use proper wire is on all the time. Battery condition. And make solid there is output. Connections. Battery voltage is use a new, below 10.7v. Charged battery. No output voltage. Thermal shut-down allow the inverter to...
6 9 3. Grounding the power inverter has a lug on the rear panel chassis ground. This is to connect the chassis of the power inverter to the ground. The ground terminals in the ac outlets on the front panel of the inverter are also connected to the ground lug. The chassis ground lug must be connect...
7 8 operation to operate the power inverter, turn it on using the on/off switch on the front panel. The power inverter is now ready to deliver ac power to your loads. If you are operating several loads from the power inverter, turn them on separately after the inverter has been turned on. This will ...
